QUESTION: 16

What happens when a Data Disk drive which has the ability to operate at 1.5 amd 3.0 Gbps is plugged into a SAS exppander port with the ability to operate at 3.0 at 6.0 Gbps?

The SATA device will not operate
The SATA drive will power down
The SAS expander port shuts down and reports an error to the management application layer using the SMP protocol
The SAS expander port and SATA device will automatically perform speed negotiation and run at 3.0 Gbps

Answer(s): D

Reveal Solution Next Question

QUESTION: 16

What must you do to implement boot from a Fibre Channel SAN in your server infrastructure?

Configure the SAN Boot setting on the Fibre Channel HB
Enable direct disk access on the SAN switch.
Enable the BIOS on the Fibre Channel HBA.
Perform a loopback data test on the Fibre Channel HBA.

Answer(s): C

Reveal Solution Next Question

A server administrator notices when a specific server is re-booted its SAN storage is sometimes visible and sometimes it is not. After examining the SAN switch logs, no FLOGI message has been received on that port. Which HBA parameter is a most likely cause?

Port Link/Speed is set to Autonegotiate.
WWPN reset timeout is set too low.
R_A_TOV does not match.
HBA Port Type is set to "E-Port"

Answer(s): A

Reveal Solution Next Question

QUESTION: 16

A customer with a split mirror backup infrastructure requires an emergency restore of a database. The data files and archive logs are co-located in the same file system. What is your first step after stopping the database?

Restore
Bring up the database in recovery mode
Copy archive logs to an alternate location
Change the database state to no archive logs

Answer(s): C

Reveal Solution Next Question

Free SG0-001 Exam Braindumps (page: 16)

QUESTION: 16

QUESTION: 16

QUESTION: 16

QUESTION: 16