QUESTION: 38

What are the types of networks supported on an Alcatel-Lucent 7750 SR for OSPF? (Choose 2)

Broadcast
Non-Broadcast Multi-Access
Point-to-Point
Point-to-Multipoint

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 38

Which of the following is an optional parameter when configuring IS-IS protocol on a router?

Configure IS-IS interfaces
Enable IS-IS
Configure level capabilities
Specify an area address

Answer(s): C

Reveal Solution Next Question

QUESTION: 39

What are the ways the RID can be created on an Alcatel-Lucent 7750 SR router? (Choose three)

From the last 32 bits of the chassis MAC address
From the first 32 bits of the chassis MAC address
The loopback IP address
By using the command "config router ospf rid X.X.X.X"
From the system IP address
From the highest interface IP address

Answer(s): A,D,E

Reveal Solution Next Question

Refer to the exhibit below. The routers have an established IS-IS L2 adjacency on which IPv4 system addresses are exchanged. An operator successfully configures multi-topology IS-IS routing so that the IPv6 system addresses are also exchanged between routers. Which of the following statements best describes the number of IS-IS adjacencies and the number of LSPs in the LSDB of R1 AFTER IPv6 has been configured?

R1 has one IS-IS adjacency and one LSP.
R1 has one IS-IS adjacency and two LSPs.
R1 has one IS-IS adjacency and four LSPs.
R1 has two IS-IS-adjacencies and two LSPs
R1 has two IS-IS adjacencies and four LSPs

Answer(s): B

Reveal Solution Next Question

Free 4A0-101 Exam Braindumps (page: 24)

QUESTION: 38

QUESTION: 38

QUESTION: 39

QUESTION: 39