QUESTION: 81

In RSTP, which state do all ports initialize in?

Designated
Discarding
Listening
Root
Forwarding

Answer(s): B

Click on the exhibit below.

Management VPLS 100 has been created for redundant spoke-SDP connections. User VPLSs 10 and 20 are using the same spoke-SDPs that are being managed by VPLS 100. Unexpected behavior has been reported. Based on the following output, what is the most likely reason for the unexpected behavior?

VPLS 100 was not actually configured as a management VPLS.
VPLS 10 and VPLS 20 are not actually configured as a user VPLS.
VPLS 10 and VPLS 20 are not using the same spoke-sdps that the management VPLS is using.
Based on the output there is now way of telling if there is a problem with the configuration.

Answer(s): A

Reveal Solution Next Question

QUESTION: 83

Click on the exhibit below.

You have been requested to add load balancing across the redundant spoke-SDPs in the network shown. What further configuration is required? (Choose 2)

An additional management VPLS.
Another set of LSPs between PE1 and PE3 and between PE2 and PE4.
Another set of SDPs between PE1 and PE3 and between PE2 and PE4.
Load balancing has to be enabled within the management VPLS.

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 84

The command "send flush-on-failure" has been enabled within a VPLS instance. What does the PE do upon detection of a SAP failure within the VPLS?

The PE sends an LDP control message that flushes all FDB entries in the VPLS instance.
The PE sends an LDP control message that flushes all FDB entries in the VPLS instance that are associated with the PE that detected the failure.
The PE flushes it's local FDB only.
The PE sends an oam service message that flushes all FDB entries in the VPLS instance.

Answer(s): B

Reveal Solution Next Question

Free 4A0-105 Exam Braindumps (page: 22)

QUESTION: 81

QUESTION: 82

QUESTION: 83

QUESTION: 84

4A0-105 Discussions & Posts