Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Alcatel-Lucent
  5. 4A0-108

Alcatel-Lucent 4A0-108 Exam
4A0-108 Multicast Protocols (Page 4 )

Updated On: 12-Feb-2026
Page 4 of 51
PDF with 247 Questions

How does a Candidate-RP send its information to the BSR?

  1. Using PIM address 224.0.0.13
  2. It is unicast to all the BSR candidates
  3. It is flooded by all PIM routers
  4. It is unicast to the elected BSR

Answer(s): D



Refer to the exhibit.



Which one of the following descriptions is correct, assuming that all the IGMP join, PIM join and multicast traffic are for the same multicast group?

  1. IGMP is enabled on Router A and B's interfaces facing the switch.
    PIM is not enabled on Router A and B's interfaces facing the switch.
    IGMP snooping is enabled on the switch.
  2. IGMP is enabled on Router A and B's interfaces facing the switch.
    PIM is not enabled on Router A and B's interfaces facing the switch.
    IGMP snooping is not enabled on the switch.
  3. IGMP is enabled on Router A and B's interfaces facing the switch.
    PIM is enabled on Router A and B's interfaces facing the switch.
    IGMP snooping is enabled on the switch.
  4. IGMP is enabled on Router A and B's interfaces facing the switch.
    PIM is enabled on Router A and B's interfaces facing the switch.
    IGMP snooping is not enabled on the switch.

Answer(s): B



When a BSR message with a higher priority is seen, will a new BSR election occur?

  1. No, the new election only occurs when the elected BSR fails
  2. Yes, after a bootstrap message wait interval
  3. Yes, immediately
  4. Depends on the local configuration of whether to allow the new election or not

Answer(s): C



Which of the following is true regarding the IPv4 multicast address format?

  1. The first 3 bits of the address set to '110'
  2. A value between 223.0.0.0 and 239.255.255.255
  3. The first 4 bits of the address set to '1111'
  4. A subnet mask to indicate the network and host portion of the address
  5. The first 4 bits of the address set to '1110'

Answer(s): E



An end station receiving a broadcast packet will always process the data up to at least which layer of the OSI stack?

  1. Layer 1
  2. Layer 2
  3. Layer 3
  4. Layer 4
  5. Layer 7

Answer(s): C






Post your Comments and Discuss Alcatel-Lucent 4A0-108 exam prep with other Community members:

Join the 4A0-108 Discussion