QUESTION: 13

CA UIM server components automate the discovery of hosts and devices throughout your network.
For discovery, which protocols are supported?

Link Layer Discovery Protocol (LLDP) and IEEE 802.1AB
Simple Service Discovery Protocol (SSDP), Neighbor Discovery Protocol (NDP), and Cisco Discovery Protocol (CDP)
SSH, WMI, SNMP, and Internet Control Message Protocol (ICMP) ping
Telnet, FTP, DNS, and Windows Management Instrumentation (WMI)

Answer(s): A

Reveal Solution Next Question

You are a CA UIM administrator in a financial organization. Your company provides and hosts agency services in a highly secure network. In some cases, one operating system is shared to host multiple services for multiple agencies. Your manager has assigned you the task of managing and monitoring each server.
However, this must be done independently for each agency. You can deploy multiple robots on each server to independently monitor the services for each agency. For the successful deployment of multiple robots, which steps must be included in your configuration plans? (Choose four.)

Delete all lines that begin with magic_key from the controller.cfg file before you copy the file to a new robot.
Ensure that the value of the controller_port setting on each robot is 48000.
Clear the niscache folder contents before copying the robot configuration.
Delete all lines that begin with magic_key from the robot.cfg file before you copy the file to a new robot.
Create a new service for each new robot.
Configure each robot on a server with a unique port range.

Answer(s): A,C,D,E

Reveal Solution Next Question

QUESTION: 15

You completed the nimldr installation on several Linux distributions. Now you need to enable the nimbus service.
Which Linux command should you run to enable the service?

systemctl enable nimbus.service
/etc/init.d/niminit start
/opt/nimsoft/bin/niminit run
/nimldr -I NMS_server_name_or_IP_address

Answer(s): A

Reference:

You must enable the nimbus service after your nimldr installation is complete. To enable the nimbus service, execute:
systemctl enable nimbus.service http://support.nimsoft.com/unsecure/archive.aspx?id=55

Reveal Solution Next Question

QUESTION: 16

You are attempting to set up monitoring on servers running Red Hat SELinux 7.1. You are unable to turn off the iptables firewall.
After getting a Linux robot up and running, you notice that the controller, spooler, and hdb robot probes all have green ports in infrastructure Manager and the controller and remote hub show no errors. However, you cannot open the controller GUI or contact it through the hub-to-robot connection. Only the connection from the robot to the hub, port 48002, works using Telnet. To address this issue, what do you need to do?

Run the service iptables stop command.
Run the /bin/systemctl stop iptables.service command.
Create the following firewall rule on the local Linux server:
ACCEPT tcp - anywhere anywhere state NEW tcp dpt:48000-48100
Run the /etc/init.d/niminit start-persistent command.

Answer(s): C

Reveal Solution Next Question

Free CAT-540 Exam Braindumps (page: 5)

QUESTION: 13

QUESTION: 14

QUESTION: 15

Reference:

QUESTION: 16

CAT-540 Exam Discussions & Posts