QUESTION: 69

Which command should be used to insert fw monitor before secxl_sync module?

fw monitor –pi –secxl_sync –o capture.cap
fw monitor –pl –secxl_sync –o capture.cap
fw monitor –pO –secxl_sync –o capture.cap
fw monitor –e “accept –pi –secxl_sync;” –o capture.cap

Answer(s): A

Reveal Solution Next Question

QUESTION: 70

What is the difference between Client-Side and Server-Side NAT?

The translation occurs at the kernel nearest the server for client-side NAT, but for server-side NAT, the translation occurs at the kernel nearest the client
The translation occurs at the kernel nearest the server in both cases. So, there is no difference at all
The translation occurs at the kernel nearest the client for client-side NAT, but for server-side NAT, the translation occurs at the kernel nearest the server
The translation occurs at the kernel nearest the client in both cases. So, there is no difference at all

Answer(s): C

Reveal Solution Next Question

QUESTION: 71

If certain services should not use the Cluster Object IP Address, but requires the use of the individual Cluster Member IPs, what steps would be required for configuration?

Create Manual NAT rules in the Security Policy
The configuration is not possible
Edit the table.def file on the Management Server
Edit the fwkern.conf on each Cluster Member

Answer(s): C

Reveal Solution Next Question

QUESTION: 72

The maximum number of critical devices or pnotes on a cluster member is what?

8
24
32
16

Answer(s): D

Reference:

https://sc1.checkpoint.com/documents/R76/CP_R76_ClusterXL_AdminGuide/7298.htm

Reveal Solution Next Question

Free 156-115.80 Exam Braindumps (page: 19)

QUESTION: 69

QUESTION: 70

QUESTION: 71

QUESTION: 72

Reference:

156-115.80 Discussions & Posts