Free 156-115.80 Exam Braindumps (page: 6)

Page 5 of 40

Which one of following commands should you run to display HTTPS packet content together with kernel debug?

  1. fw ctl get int https_inspection_show_decrypted_data_in_debug=1
    fw ctl get int ssl_inspection_extra_debug=1
  2. fw set int https_inspection_get_encrypted_data_in_debug 1
    fw set int https_inspection_show_debug 1
  3. fw ctl set int https_inspection_show_decrypted_data_in_debug 1
    fw ctl set int ssl_inspection_extra_debug 1
  4. fw ctl set int http_inspection_display_encrypted_data_in_debug=1
    fw ctl set int http_inspection_extra_debug=1

Answer(s): C



You issued the command “set ipv6-state on” in order to enable IPv6 protocol on a Security Gateway. The command was executed successfully. After reboot you notice that IPv6 protocol is not enabled. What do you do to permanently enable IPv6 protocol?

  1. Issue “set ipv6-state on” again; Save configuration and reboot
  2. You need to modify Gateway Properties in SmartConsole and install policy in order to enable IPv6
  3. You need to set “ipv6_state” parameter in $FWDIR/boot/modules/fwkern.conf and reboot
  4. You need to install a valid license to use IPv6 protocol

Answer(s): A



Where does the translation occur with Hide NAT?

  1. The destination translation occurs at the client side
  2. The source translation occurs at the server side
  3. The source translation occurs at the client side
  4. The destination translation occurs at the server side

Answer(s): B



Fill in the blank. The tool _____ generates a R80 Security Gateway configuration report.

  1. infoCP
  2. infoview
  3. cpinfo
  4. fw cpinfo

Answer(s): C






Post your Comments and Discuss Checkpoint 156-115.80 exam with other Community members:

156-115.80 Discussions & Posts