QUESTION: 193

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

lldp timer
lldp tlv-select
lldp reinit
lldp holdtime

Answer(s): C

Explanation:

“¢ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it
“¢ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface
“¢ lldp timer rate: Set the sending frequency of LLDP updates in seconds

Reference:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swlldp.html

Reveal Solution Next Question

QUESTION: 194

Refer to the exhibit. How does SW2 interact with other switches in this VTP domain?

It transmits and processes VTP updates from any VTP clients on the network on its trunk ports.
It processes VTP updates from any VTP clients on the network on its access ports.
It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports.
It forwards only the VTP advertisements that it receives on its trunk ports.

Answer(s): D

Explanation:

The VTP mode of SW2 is transparent so it only forwards the VTP updates it receives to its trunk links without processing them.

Reference:

https://www.cisco.com/c/en/us/support/docs/lan-switching/vtp/10558-21.html

Reveal Solution Next Question

QUESTION: 195

Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

mode on
active
passive
auto

Answer(s): B

Explanation:

From the neighbor status, we notice the “Flags” are SP. “P” here means the neighbor is in Passive mode. In order to create an Etherchannel interface, the (local) SW1 ports should be in Active mode. Moreover, the “Port State” in the exhibit is “0x3c” (which equals to “00111100”³ in binary format). Bit 3 is “1” which means the ports are synchronizing -> the ports are working so the local ports should be in Active mode.

Reveal Solution Next Question

QUESTION: 196

Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?

The link becomes an access port.
The link is in an error disabled state.
The link is in a down state.
The link becomes a trunk port.

Answer(s): D

Reveal Solution Next Question

Free 200-301 Exam Braindumps (page: 49)

QUESTION: 193

Explanation:

Reference:

QUESTION: 194

Explanation:

Reference:

QUESTION: 195

Explanation:

QUESTION: 196