Cisco®
Oracle
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
Microsoft
VMware
Avaya
SAP
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 200-301

Free Cisco® 200-301 Exam Braindumps (page: 50)

Page 50 of 350
PDF with 1395 Questions

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

  1. lldp timer
  2. lldp tlv-select
  3. lldp reinit
  4. lldp holdtime

Answer(s): C

Explanation:

“¢ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it
“¢ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface
“¢ lldp timer rate: Set the sending frequency of LLDP updates in seconds


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swlldp.html



Refer to the exhibit. How does SW2 interact with other switches in this VTP domain?

  1. It transmits and processes VTP updates from any VTP clients on the network on its trunk ports.
  2. It processes VTP updates from any VTP clients on the network on its access ports.
  3. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports.
  4. It forwards only the VTP advertisements that it receives on its trunk ports.

Answer(s): D

Explanation:

The VTP mode of SW2 is transparent so it only forwards the VTP updates it receives to its trunk links without processing them.


Reference:

https://www.cisco.com/c/en/us/support/docs/lan-switching/vtp/10558-21.html



Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

  1. mode on
  2. active
  3. passive
  4. auto

Answer(s): B

Explanation:

From the neighbor status, we notice the “Flags” are SP. “P” here means the neighbor is in Passive mode. In order to create an Etherchannel interface, the (local) SW1 ports should be in Active mode. Moreover, the “Port State” in the exhibit is “0x3c” (which equals to “00111100”³ in binary format). Bit 3 is “1” which means the ports are synchronizing -> the ports are working so the local ports should be in Active mode.



Two switches are connected and using Cisco Dynamic Trunking Protocol. SW1 is set to Dynamic Auto and SW2 is set to Dynamic Desirable. What is the result of this configuration?

  1. The link becomes an access port.
  2. The link is in an error disabled state.
  3. The link is in a down state.
  4. The link becomes a trunk port.

Answer(s): D



Viewing page 50 of 350
Viewing questions 197 - 200 out of 1395 questions



Post your Comments and Discuss Cisco® 200-301 exam prep with other Community members:

200-301 Exam Discussions & Posts