CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 200-301

Free 200-301 Exam Braindumps (page: 7)

Page 6 of 350
PDF with 1395 Questions

Which action is taken by switch port enabled for PoE power classification override?

  1. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled.
  2. When a powered device begins drawing power from a PoE switch port, a syslog message is generated.
  3. As power usage on a PoE switch port is checked, data flow to the connected device is temporarily paused.
  4. If a switch determines that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it.

Answer(s): A

Explanation:

PoE monitoring and policing compares the power consumption on ports with the administrative maximum value (either a configured maximum value or the port's default value). If the power consumption on a monitored port exceeds the administrative maximum value, the following actions occur:
- A syslog message is issued.
- The monitored port is shut down and error-disabled.
- The allocated power is freed.


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.pdf



What occurs to frames during the process of frame flooding?

  1. Frames are sent to all ports, including those that are assigned to other VLANs.
  2. Frames are sent to every port on the switch that has a matching entry in MAC address table.
  3. Frames are sent to every port on the switch in the same VLAN except from the originating port.
  4. Frames are sent to every port on the switch in the same VLAN.

Answer(s): C



Which function does the range of private IPv4 addresses perform?

  1. allows multiple companies to each use the same addresses without conflicts
  2. provides a direct connection for hosts from outside of the enterprise network
  3. ensures that NAT is not required to reach the Internet with private range addressing
  4. enables secure communications to the Internet for all external hosts

Answer(s): A



Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?

  1. explicitly assign a link-local address
  2. disable the EUI-64 bit process
  3. enable SLAAC on an interface
  4. configure a stateful DHCPv6 server on the network

Answer(s): C






Post your Comments and Discuss Cisco® 200-301 exam with other Community members:

200-301 Discussions & Posts