Free 300-410 Exam Braindumps
Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) Questions 329–336 (page: 43)

Updated On: 9-Jul-2026

Refer to the Exhibit. The access-lists are configured on the network device. There is a server behind the network device. User are trying to access the server securely however they are not able to access it. What changes would you recommend to the above configuration?

  1. Permit tcp port 465
  2. Permit tcp port 3389
  3. Permit tcp port 443
  4. Permit tcp any any

Answer(s): C



Which of the following is true regarding IPsec Pre-fragmentation (Look-Ahead Fragmentation)? (Choose two.)

  1. Operates in tunnel mode only
  2. Operates in transport mode only
  3. Is used to help in the overall IPsec throughput since the end host is able to avoid packet reassembly after packet decryption.
  4. Is not dependent on the MTU of the physical interface used for IPsec.
  5. Does not support Path MTU Discovery

Answer(s): A,C



Which of the following correctly describes the concept of split horizon with IP routing? (Choose two.)

  1. Split horizon is a valid routing loop prevention mechanism
  2. Split horizon is used to filter customer routes in an ISP network.
  3. When enabled, split horizons informs the router to not advertise routes back out the same interface from where that route was originally received.
  4. Split horizons cannot be disabled on WAN interfaces
  5. Split horizon is not applicable to EIGRP networks

Answer(s): A,C



DRAG DROP (Drag and Drop is not supported)
Arrange the below as per the recommended steps:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



A network administrator is reloading a router and during the bootup, he is getting the error message “%Error opening tftp://255.255.255.255/network-confg (Socket error)”. What command need to be applied on Cisco Router to fix this issue.

  1. No service config
  2. Write erase reload
  3. Reload noconfirm
  4. Copy run start

Answer(s): A



DRAG DROP (Drag and Drop is not supported)
The steps for configuring BGP on Cisco IOS Router:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



What is the term used when it causes the packets to lose their MPLS labels including the VPN in-formation that lies in the inner MPLS Label i.e. if a packet goes through an untagged interface, the VPN information is lost and VPN sites lose connectivity?

  1. Pseudowire
  2. Black Hole
  3. Traffic Engineering
  4. Active Network Abstraction

Answer(s): B



An administrator wants to implement security on his company’s router. Please select three options that you will use on your router to secure it. (Choose three.)

  1. Control Access to the router
  2. Restrict all traffic through the router
  3. Restrict SNMP
  4. Enable all unused services
  5. Encrypt all passwords
  6. Disable logging

Answer(s): A,C,E



Viewing page 43 of 81
Viewing questions 337 - 344 out of 640 questions


Post your Comments and Discuss Cisco 300-410 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!