Free 300-425 Exam Braindumps

A network engineer is preparing for an office site survey with a height of 2.5 meters. Which three components are recommended to complete the survey? (Choose three.)

  1. Use a battery pack to power APs.
  2. Use a drawing of the office space to draw AP and client placements.
  3. Use DoS attack on APs while measuring the throughput.
  4. Use APs with directional antennas.
  5. Use APs with external antennas.
  6. Use APs with built-in antennas.

Answer(s): A,B,F



An engineer performs a Layer 1 survey by using Metageek Chanalyzer only on the current operating channel. Which operating mode is configured for a Cisco CleanAir AP?

  1. monitor
  2. local
  3. sniffer
  4. SE-connect

Answer(s): B



A customer has restricted the AP and antenna combinations for a design to be limited to one model integrated antenna AP for carpeted spaces and one morel external antenna AP, with high gain antennas for industrial, maintenance, or storage areas. When moving between a carpeted area to an industrial area, the engineer forgets to change survey devices and surveys several APs. Which strategy will reduce the negative impact of the design?

  1. Deploy unsurveyed access points to the design.
  2. Increase the Tx power on incorrectly surveyed access points.
  3. Deploy the specified access points per area type.
  4. Resurvey and adjust the design.

Answer(s): D



Refer to the exhibit.


During a post Mesh deployment survey, an engineer notices that frame collisions occur when MAP-1 and MAP-3 talk to RAP-2. Which type of issue does the engineer need to address in the design?

  1. co-channel interference
  2. hidden node
  3. backhaul latency
  4. exposed node

Answer(s): B



During a post deployment site survey, issues are found with non-Wi-Fi interference. What should the engineer use to identify the source of the interference?

  1. wireless intrusion prevention
  2. Cisco Spectrum Expert
  3. Wireshark
  4. network analysis module

Answer(s): B