Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
Scrum
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 300-510

Free 300-510 Exam Braindumps (page: 9)

Page 8 of 61
PDF with 269 Questions

Refer to the exhibit. Routers RA and RB are IS-IS peers configured for NSF, but router RC is an IS-IS peer without NSF capability. If RA undergoes processor switchover, what is the effect on the network environment?

  1. If RC is operating without the Cisco configuration option, only 2 routers tear down their peering relationships and re-establish peering
  2. All peer relationships remain up, but the link-state database is rebuilt on each device
  3. If RC is operating without the Cisco configuration option, all three routers tear down their peering relationships and re-establish peering
  4. All peer relationships remain up and the link-state database is unchanged

Answer(s): B



Refer to the exhibit. An engineer working for a private telecommunication company with an employee id: 1234:09:567 implemented this configuration on Router1, what is the effect of it?

  1. Router 1 receives only one best path from neighbor 192.168.1.1
  2. Router 1 sends only one best path to neighbor 192.168.1.1
  3. Router 1 sends up to three paths to neighbor 192.168.1.1 for all routes
  4. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1

Answer(s): D



Refer to the exhibit. While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?

  1. Modify the IP address or mask of the interface to a valid one
  2. Set up a priority different than 0 in the interface
  3. Modify the router ID to be the interface IP on the serial
  4. Set the network type in S1/0 to point-to-point

Answer(s): A



After an engineer configures BGP in R1, it starts receiving this message:

Which action makes the peering come back up again?

  1. Make a soft reset to the peer
  2. Set up a hello timer higher
  3. Set up a hold-down timer higher
  4. Set up a minimum hold-down timer higher

Answer(s): D






Post your Comments and Discuss Cisco® 300-510 exam with other Community members: