QUESTION: 41 Exam Topic: Compute Platforms

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

1. Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2. Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3. Check for runtime link down status.
4. Reseat the affected IOM.
1. Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2. Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3. Check for runtime link down status.
4. Reseat the affected IOM.
1. Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2. Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3. Check for runtime link down status.
4. Reseat the affected IOM.
1. Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2. Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3. Check for runtime link down status.
4. Reseat the affected IOM.

Answer(s): B

Reference:

https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ts/guide/UCSTroubleshooting/UCSTroubleshooting_chapter_01001.html

Reveal Solution Next Question

QUESTION: 42 Exam Topic: Compute Platforms

Refer to the exhibit. A network engineer traces the packet flow from the Veth991 of a blade server toward the core switch. The switch reports performance issues. What is the role of the interface Eth1/7?

IOM network interface
fabric interconnect uplink interface
IOM host interface
server interface

Answer(s): B

Reveal Solution Next Question

QUESTION: 43 Exam Topic: Compute Platforms

A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network. Which action resolves the issue?

Build a new service profile with the desired network configuration.
Remove all existing vNICs and add them in the desired order.
Create a vNIC placement policy to avoid adapter renumbering.
Add the disjoint Layer 2 VLANs to an existing vNIC rather than adding new vNICs.

Answer(s): C

Reference:

https://www.cisco.com/c/en/us/support/docs/hyperconverged-infrastructure/hyperflex-hx- dataplatform/213665-troubleshoot-hx-nodes-pci-address-reorde.html

Reveal Solution Next Question

QUESTION: 44 Exam Topic: Compute Platforms

Refer to the exhibits. An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server. Which set of actions resolves this problem?

Bind native VLAN 10 with Ethernet1/10 and allow VSAN 101 in trunk configuration.
Assign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.
Bind native VLAN 10 with Ethernet10/1/1 and allow VLAN 10 in trunk configuration.
Assign native VLAN 10 with fc2/1 - 2 and allow VLAN 10 in trunk configuration.

Answer(s): C

Reveal Solution Next Question

Free 300-615 Exam Braindumps (page: 11)

QUESTION: 41 Exam Topic: Compute Platforms

Reference:

QUESTION: 42 Exam Topic: Compute Platforms

QUESTION: 43 Exam Topic: Compute Platforms

Reference:

QUESTION: 44 Exam Topic: Compute Platforms