2. Home
  3. Catalog
  4. Cisco®
  5. 300-615

Free 300-615 Exam Braindumps

A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)

  1. Configure the NVE interfaces to be Up on both switches.
  2. Set a different distributed gateway virtual MAC address.
  3. Set a different secondary IP addresses on NVE source-interface.
  4. Configure the same VNI to multicast group maping.
  5. Set a different primary IP addresses on NVE source-interface.

Answer(s): A,D



Refer to the exhibit. The vPCneighborship between two switches is in suspended state. Which configuration change resolves the issue and brings up the vPCneighborship?

  1. Change STP Port Type to Network on the peer switch
  2. Enable Bridge Assurance on the local switches
  3. Configure QoS MTU value of 9216 on the peer switch
  4. Add VLAN 400-401 to the configuration on the local switch

Answer(s): C


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/troubleshooting/guide/N5K_Troubleshooting_Guide/n5K_ts_vpc.pdf



An engineer is implementing a new BGP peering in their new data center. The engineer set up the BGP session that peers with the remote end. As soon as the BGP peers attempt to exchange routing prefixes, one of the BGP peers drops the connection. After reviewing the configuration, the engineer reviews the logging messages. The engineer discovers that the router is missing keepalives from the remote end and terminates the session. Which action resolves the issue?

  1. Set the bgp transport path-mtu-discovery attribute on both peers
  2. Set the higher values for the BGP keepalive and hold-down timers on both peers
  3. Configure the matching BGP AS numbers between the peers
  4. Configure the matching BGP passwords between the peers

Answer(s): B



Refer to the exhibit A customer network uses OSPFv2 and MP-BGP protocols A network administrator installs a new Cisco Nexus Switch in the data center but experiences a BGP RIB failure Which action solves theissue?

  1. Change the administrative distance of OSPF to 220
  2. Configure the route as a BGP backdoor
  3. Use a filter list for OSPF to filter both routes
  4. Implement next-hop-self

Answer(s): D



Refer to the exhibit. An engineer troubleshoots an OSPF neighborship problem between Router R2 and Router R10. Which action resolves the problem?

  1. Change area ID on Router R10
  2. Resolve unicast reply from Router R2
  3. Resolve authentication type on Router R10
  4. Change router ID on Router R10

Answer(s): B




300-615 PDF Dump

Allbraindumps.com
Test Questions PDF from Myitguides.com

Test Questions PDF from Myitguides.com