A network engineer must deploy a Cisco ASA to an existing network without changing any IP addresses or networking settings. The external devices connected to the firewall will be on the same subnet as the internal devices. Which command must the engineer use to meet the requirements?
Answer(s): A
To deploy a Cisco ASA without changing existing IP addresses or network topology, the firewall must operate in transparent mode. The firewall transparent command enables this mode, allowing the ASA to act as a Layer 2 bridge, where internal and external devices remain on the same subnet while still enforcing security policies.
Which communication is blocked from the bridge groups when multiple are configured in transparent mode on a Cisco Secure Firewall Threat Defense appliance?
Answer(s): C
On a Cisco Secure Firewall Threat Defense appliance operating in transparent mode, multiple bridge groups are isolated from each other. Traffic is blocked between bridge groups by default, and communication is only allowed within the same bridge group unless explicitly routed or permitted through additional configuration.
How should a high-availability pair of Cisco Secure Firewall Threat Defense Virtual appliances be deployed to Cisco Secure Firewall Management Center?
Answer(s): B
For Cisco Secure Firewall Threat Defense Virtual (FTDv) appliances in a high-availability pair, you must first configure high availability directly on the FTD appliances, then register only the primary unit to Cisco Secure Firewall Management Center (FMC). FMC automatically detects and manages the secondary unit as part of the HA pair after the primary is added.
An engineer is implementing clustering in Cisco Secure Firewall Management Center. The configuration must ensure that the cluster has a designated control unit node with more resources than the other nodes. What must the engineer set for the priority value of the node?
In a Cisco Secure Firewall clustering deployment, the node with the highest priority value becomes the control unit. To ensure a specific node with more resources takes the control role, the engineer must assign it a priority higher than all other nodes in the cluster.
An engineer is configuring a Cisco Secure Firewall Threat Defense device to operate in transparent mode between two switch stacks. VLAN 10 is used for in-band management on both switch stacks. Which two actions are required on the device to inspect traffic between the two switch stacks without causing any interruption to network traffic? (Choose two.)
Answer(s): D,E
In transparent mode, a Cisco Secure Firewall Threat Defense (FTD) device must be configured with:A Bridge Virtual Interface (BVI) for management access (e.g., VLAN 10) since it does not participate in IP routing.At least one bridge group to enable traffic forwarding between interfaces (i.e., the switch stacks), as transparent mode uses bridging at Layer 2 to inspect traffic.These two actions allow the device to inspect traffic without disrupting the Layer 2 forwarding behavior of the existing network.
Post your Comments and Discuss Cisco 300-710 exam prep with other Community members:
Our website is free, but we have to fight against AI bots and content theft. We're sorry for the inconvenience caused by these security measures. You can access the rest of the 300-710 content, but please register or login to continue.