QUESTION: 165

Refer to the exhibit. R1 is able to ping the R3 fa0/1 interface.
Why do the extended pings fail?

The maximum packet size accepted by the command is 1476 bytes.
The DF bit has been set.
R3 is missing a return route to 10.99.69.0/30.
R2 and R3 do not have an OSPF adjacency.

Answer(s): B

Reveal Solution Next Question

QUESTION: 166

Refer to the exhibit.
Which command allows hosts that are connected to FastEthernet0/2 to access the Internet?

ip nat inside source list 10 interface FastEthernet0/2 overload
ip nat inside source list 10 interface FastEthernet0/1 overload
ip nat outside source static 209.165.200.225 10.10.10.0 overload
ip nat outside source list 10 interface FastEthernet0/2 overload

Answer(s): B

Reveal Solution Next Question

QUESTION: 167

Refer to the exhibit.
What are two effects of this configuration? (Choose two.)

If R1 goes down, R2 becomes active but reverts to standby when R1 comes back online.
If R2 goes down, R1 becomes active but reverts to standby when R2 comes back online.
R1 becomes the active router.
R1 becomes the standby router.
If R1 goes down, R2 becomes active and remains the active device when R1 comes back online.

Answer(s): C,E

Reveal Solution Next Question

Refer to the exhibit. An engineer must ensure that all traffic entering AS 200 from AS 100 chooses Link 2 as an entry point. Assume that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers.
Which configuration accomplishes this task?

R3(config)#route-map PREPEND permit 10 R3(config-route-map)#set as-path prepend 200 200 200 R3(config)#router bgp 200 R3#(config-router)#neighbor 10.1.1.1 route-map PREPEND out
R4(config)#route-map PREPEND permit 10 R4(config-route-map)#set as-path prepend 100 100 100 R4(config)#router bgp 200 R4(config-router)#neighbor 10.2.2.2 route-map PREPEND in
R4(config)#route-map PREPEND permit 10 R4(config-route-map)#set as-path prepend 200 200 200 R4(config)#router bgp 200 R4(config-router)#neighbor 10.2.2.2 route-map PREPEND out
R3(config)#route-map PREPEND permit 10 R3(config-route-map)#set as-path prepend 100 100 100 R3(config)#router bgp 200 R3(config-router)#neighbor 10.1.1.1 route-map PREPEND in

Answer(s): A

Reveal Solution Next Question

Free 350-401 Exam Braindumps (page: 42)

QUESTION: 165

QUESTION: 166

QUESTION: 167

QUESTION: 168