Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Cisco
  5. 350-401

Cisco 350-401 Exam Questions
Implementing Cisco Enterprise Network Core Technologies (ENCOR) (Page 10 )

Updated On: 9-Mar-2026
Page 10 of 193
PDF with 1067 Questions

While configuring an IOS router for HSRP with a virtual IP of 10.1.1.1, an engineer sees this log message.

Jan 1 12:12:12.111 : %HSRP-4-DIFFVIP1: GigabitEthernet0/0 Grp 1 active routers virtual IP address 10.1.1.1 is different to the locally configured address 10.1.1.25

Which configuration change must the engineer make?

  1. Change the HSRP group configuration on the local router to 1.
  2. Change the HSRP virtual address on the local router to 10.1.1.1.
  3. Change the HSRP virtual address on the remote router to 10.1.1.1.
  4. Change the HSRP group configuration on the remote router to 1.

Answer(s): B



A network administrator has designed a network with two multilayer switches on the distribution layer, which act as default gateways for the end hosts. Which two technologies allow every end host in a VLAN to use both gateways? (Choose two.)

  1. VRRP
  2. GLBP
  3. VSS
  4. MHSRP
  5. HSRP

Answer(s): B,D



Refer to the exhibit. On which interfaces should VRRP commands be applied to provide first hop redundancy to PC-01 and PC-02?

  1. G0/0 and G0/1 on Core
  2. G0/0 on Edge-01 and G0/0 on Edge-02
  3. G0/1 on Edge-01 and G0/1 on Edge-02
  4. G0/0 and G0/1 on ASW-01

Answer(s): C



Under which network conditions is an outbound QoS policy that is applied on a router WAN interface most beneficial?

  1. under traffic classification and marking conditions
  2. under interface saturation conditions
  3. under all network conditions
  4. under network convergence conditions

Answer(s): B



An engineer must configure HSRP group 300 on a Cisco IOS router. When the router is functional, it must be the active HSRP router. The peer router has been configured using the default priority value. Which command set is required?

  1. standby version 2 standby 300 priority 110 standby 300 pre-empt
  2. standby 300 priority 110 standby 300 timers 1 110
  3. standby version 2 standby 300 priority 90 standby 300 pre-empt
  4. standby 300 priority 90 standby 300 pre-empt

Answer(s): A



Viewing page 10 of 193
Viewing questions 46 - 50 out of 1067 questions



Post your Comments and Discuss Cisco 350-401 exam dumps with other Community members:

350-401 Exam Discussions & Posts

AI Tutor