Free 350-401 Exam Braindumps (page: 27)

Page 26 of 268

What is the function of a VTEP in VXLAN?

  1. provide the routing underlay and overlay for VXLAN headers
  2. dynamically discover the location of end hosts in a VXLAN fabric
  3. encapsulate and de-encapsulate traffic into and out of the VXLAN fabric
  4. statically point to end host locations of the VXLAN fabric

Answer(s): C



Refer to the exhibit.
Which configuration must be applied to R1 to enable R1 to reach the server at 172.16.0.1?

  1. interface Ethernet0/0 ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf bank network 172.16.0.0 255.255.0.0
  2. interface Ethernet0/0 vrf forwarding hotel ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf Hotel network 172.16.0.0 0.0.255.255 area 0
  3. interface Ethernet0/0 vrf forwarding bank ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf bank network 172.16.0.0 0.0.255.255 area 0
  4. interface Ethernet0/0 ip address 172.16.0.7 255.255.0.0 router ospf 44 vrf hotel network 172.16.0.0 255.255.0.0

Answer(s): C



Refer to the exhibit.
Which configuration allows Customer2 hosts to access the FTP server of Customer1 that has the IP address of 192.168.1.200?

  1. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20
  2. ip route vrf Customer1 172.16.1.1 255.255.255.255 172.16.1.1 global ip route vrf Customer2 192.168.1.200 255.255.255.0 192.168.1.1 global ip route 192.168.1.0 255.255.255.0 Vlan10 ip route 172.16.1.0 255.255.255.0 Vlan20
  3. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 Customer2 ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 Customer1
  4. ip route vrf Customer1 172.16.1.0 255.255.255.0 172.16.1.1 Customer1 ip route vrf Customer2 192.168.1.200 255.255.255.255 192.168.1.1 Customer2

Answer(s): A



Refer to the exhibit. A network engineer configures a new GRE tunnel and enters the show run command.
What does the output verify?

  1. The tunnel keepalive is configured incorrectly because they must match on both sites.
  2. The tunnel destination will be known via the tunnel interface.
  3. The tunnel will be established and work as expected.
  4. The default MTU of the tunnel interface is 1500 bytes.

Answer(s): B






Post your Comments and Discuss Cisco® 350-401 exam prep with other Community members:

350-401 Exam Discussions & Posts