Free 350-501 Exam Braindumps
Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) Questions 145–152 (page: 20)

Updated On: 28-Apr-2026
View Related Case Study



Refer to the exhibit Which effect of this configuration is true?

  1. R1 can support a peer that is configured for LDP SSO/NSF as the peer recovers from an outage.
  2. R1can support a graceful restart operation on the peer, even if graceful restart is disabled on the peer.
  3. R1 can failover to any peer.
  4. R1 can failover only to a peer that is configured for LDF SSO/NSF.

Answer(s): A


Reference:

https://www.cisco.com/en/US/docs/general/Test/kwoodwar/fsgr29s.html



View Related Case Study

You are testing the capabilities of MPLS OAM ping. Which statement is true?

  1. An LSP is not required for the reply to reach the ingress MPLS router.
  2. An LSP breakage results in the ingress MPLS router never receiving any reply.
  3. MPLS OAM ping works solely with P2P LSPs.
  4. MPLS OAM ping works solely with Cisco MPLS TE.

Answer(s): A


Reference:

https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r5-3/mpls/configuration/ guide/b-mpls-cg53x-asr9k/b-mpls-cg53x-asr9k_chapter_01000.html



View Related Case Study

In an MPLS network, which protocol can be used to distribute a Segment Prefix?

  1. LDP
  2. EIGRP
  3. OSPF
  4. RSVP-TE

Answer(s): C



View Related Case Study



Refer to the exhibit. With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?

  1. 192.168.0.4
  2. 192.168.0.5
  3. 192.168.0.1
  4. 192.168.0.3

Answer(s): B



View Related Case Study



Refer to the exhibit. A network operator working for service provider with an employee id: 1234:56:789 applied this configuration to a router.

Which additional step should the engineer use to enable LDP?

  1. Enable MPLS LDP on the interface.
  2. Disable Cisco Express Forwarding globally.
  3. Delete the static router ID.
  4. Configure the both keyword to enable LDP globally.

Answer(s): A



View Related Case Study

Which utility can you use to locate MPLS faults?

  1. MPLS LSP ping
  2. QoS
  3. MPLS traceroute
  4. EEM

Answer(s): C



View Related Case Study

When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not tacking the expected path in the core.

Which command do you use to quickly check path of a TE tunnel?

  1. traceroute <tunnel destination IP>
  2. show mpls traffic-engineering tunnels
  3. Ping <tunnel destination IP>
  4. traceroute mpls ipv4 <tunnel destination>

Answer(s): D



View Related Case Study

DRAG DROP (Drag and Drop is not supported)

Drag and drop the LDP features from the left onto the correct usages on the right.

Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



Viewing page 20 of 66
Viewing questions 153 - 160 out of 515 questions


Post your Comments and Discuss Cisco 350-501 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!