Cisco 350-801 Exam
Implementing Cisco Collaboration Core Technologies (CLCOR) (Page 10 )

Updated On: 12-Feb-2026

Refer to the exhibit.



Cisco Unified Border Element is attempting to establish a call with Subscriber 1, but the call fails. Cisco Unified Border Element then retries the same call with Subscriber 2, and the call proceeds normally.
Which action resolves the issue?

  1. Verify that the Run On All Active Unified CM Nodes checkbox is enabled.
  2. Verify that the correct calling search space is selected for the Inbound Calls section.
  3. Verify that the Significant Digits field for Inbound Calls is set to All.
  4. Verify that the PSTN Access checkbox is enabled.

Answer(s): A



Refer to the exhibit.


A collaboration engineer is configuring the Cisco UCM IM and Presence Service.
Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)

  1. Check the box to accept replaces header.
  2. Check the box to allow charging header.
  3. Check the box to enable application-level authorization.
  4. Check the box to transmit security status.
  5. Check the box to accept unsolicited notification.

Answer(s): A,E


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/im_presence/ configAdminGuide/12_0_1/cup0_b_config-admin-guide-imp-1201/cup0_b_config-admin-guide-imp- 1201_chapter_0100.html



Refer to the exhibit.



An engineer is troubleshooting this video conference issue:
A video call between a Cisco 9971 in Region1 and another Cisco 9971 in Region1 works.

As soon as the Cisco 9971 in Region1 conferences in a Cisco 8945 in Region2, the Region1 endpoint cannot see the Region2 endpoint video.

What is the cause of this issue?

  1. Cisco 8945 does not have a camera connected.
  2. Maximum Audio Bit Rate must be increased.
  3. Maximum Session Bit Rate for Video Calls is too low.
  4. Maximum Session Bit Rate for Immersive Video Calls is too low.

Answer(s): C



If a phone needs to register with cucm1.cisco.com, which network service assists with the phone registration process?

  1. SMTP
  2. ICMP
  3. DNS
  4. SNMP

Answer(s): C



Cisco Prime Collaboration Manager is using Cisco Discovery Protocol to discover devices in an automated setup.
What must be used to get alerts and faults via traps from the devices at regular polling intervals?

  1. CDP
  2. XML
  3. SNMP
  4. HTTPS

Answer(s): C






Post your Comments and Discuss Cisco 350-801 exam prep with other Community members:

Join the 350-801 Discussion