QUESTION: 49

Study the exhibit carefully. Configure P4S-R1, P4S-R2, and P4S-R3 to run EIGRP on all their connected interfaces. P4S-R2 is also configured as an EIGRP stub. Which EIGRP routes are in the local topology table at P4S-R3?

172.30.2.0/24, 172.30.3.0/31 and 172.30.3.2/31
172.30.0.0/16
There's not enough information provided to know what would be in the topology table atP4S- R3.
172.30.1.0/24, 172.30.2.0/24, 172.30.3.0/31 and 172.30.3.2/31

Answer(s): A

Reveal Solution Next Question

QUESTION: 50

Which two reasons are for incrementing your network and network devices to collect performance data? (Choose two.)

To route traffic around constrained choke points in the network
To enable capacity planning decisions
To determine the impact of jitter and latency on application performance
To determine the locations at which QoS needs to be implemented

Answer(s): B,D

Reveal Solution Next Question

QUESTION: 51

In this network presented in the following exhibit, traffic destined for 10.1.3.1 arrives at P4S-R5. Which path will be taken by the traffic from here and why?

It will take the path P4S-R3, P4S-R2, P4S-R1, because OSPF always prefers paths within an area.
It will not take any path; the traffic will be dropped because P4S-R2 is in a different autonomous system than P4S-R1 orP4S-R3.
It will take the path the path P4S-R4, P4S-R3, P4S-R2, P4S-R1, because this is the lowest cost path.
It will not take any path; the traffic will be dropped because the summary (type 3) LSA advertised by P4S-R1 into area 1 will not be readvertised back into area 0.

Answer(s): D

Reveal Solution Next Question

QUESTION: 52

When is the site-to-site remote access model appropriate?

For multiple ISDN connections
For modem concentrated dial-up connections
For a group of users in the same vicinity sharing a connection
For use by mobile users

Answer(s): C

Reveal Solution Next Question

Free 351-001 Exam Braindumps (page: 13)

QUESTION: 49

QUESTION: 50

QUESTION: 51

QUESTION: 52