Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Cisco
  5. 351-001

Cisco 351-001 Exam Questions
CCIE Routing and Switching v4.0 Written Beta (Page 16 )

Updated On: 6-Apr-2026
Page 9 of 49
PDF with 234 Questions

Which is the reason that EIGRP uses queries?

  1. To test known alternate paths and determine if they are loop-free
  2. To find alternate loop-free paths that have been discarded due to split horizons
  3. To test for neighbor state when the network topology is in flux
  4. To withdraw routing information from the network

Answer(s): B



In a single broadcast domain, connect three routers via a standard Ethernet switch. STP is the only Layer 2 protocol running on this link. EIGRP is the only Layer 3 protocol running on this link, which uses a standard configuration. Then, one of the three routers is manually shut down. How will the other two routers discover the loss of this neighbor?

  1. The switch will send a reverse ARP when the router disconnects from the switch.
  2. The line protocol on the remaining two routers will be brought down as soon as the carrier is lost from the switch.
  3. The EIGRP dead timers will expire due to the absence of EIGRP traffic.
  4. The switch will bring down the carrier on all ports momentarily to force all the routers connected to the link to relearn their neighbors.

Answer(s): C



Which two network design principles does this network violate on the basis of the following exhibit? (Choose two.)

  1. Hierarchy
  2. Predictability
  3. Fault tolerance
  4. Modularity

Answer(s): A,D



A Fibre Channel fabric (or Fibre Channel switched fabric, FC-SW) is a switched fabric of Fibre Channel devices enabled by a Fibre Channel switch. Fabrics are normally subdivided by Fibre Channel zoning. Each fabric has a name server and provides other services. Higher redundancy over FC-AL, P2P.Which path selection protocol is used by Fibre Channel fabrics?

  1. OSPF
  2. RIP
  3. FSPF
  4. VSANs

Answer(s): C



While deploying IGP non-stop forwarding (NSF), which practice is the best for tuning routing protocol hello and dead timers?

  1. The hello and dead timers should be tuned to allow NSF to continue forwarding after an initial failure detection.
  2. The routing protocol hello and dead timers should be decreased to the minimum.
  3. NSF-independent timers should be used so that routing protocol timers have no effect.
  4. The hello and dead timers should be tuned so the link failure is detected before NSF has the chance to react to the failure.

Answer(s): A



Viewing page 16 of 49
Viewing questions 76 - 80 out of 234 questions



Post your Comments and Discuss Cisco 351-001 exam dumps with other Community members:

351-001 Exam Discussions & Posts

AI Tutor AI Tutor 👋 I’m here to help!