CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Cisco®
  5. 351-001

Free 351-001 Exam Braindumps (page: 6)

Page 5 of 60
PDF with 234 Questions

When designing a converged network, which measures can be taken at the building access layer to help eliminate latency and ensure end-to-end quality of service can be maintained? (Choose three.)

  1. Rate limit voice traffic
  2. On figure spanning-tree for fast link convergence
  3. Isolate voice traffic on separate VLANs
  4. Classify and mark traffic close to the source

Answer(s): B,C,D



Which two reasons are correct about building a flooding domain boundary in a link-state network? (Choose two.)

  1. To increase the size of the Shortest Path First tree
  2. To aggregate reach ability information
  3. To provide an administrative boundary between portions of the network
  4. To segregate complex and rapidly changing portions of the network from one another

Answer(s): B,D



The P4S company is planning to deploy a new multicast application in its network to do real-time trading. This application will be performed simultaneously by thousands of traders located Throughout the network, each a source of several IP multicast streams, to carry the "sell" and "buy" trading bids. All routers in its network have full hardware support for all PIM multicast modes. Which mode can be used to minimize the impact of the new application on the routers in the P4S network?

  1. PIM Source Specific Multicast
  2. PIM Any-Source Multicast
  3. PIM Dense Mode
  4. PIM Bidirectional

Answer(s): D



You work as a network technician for the P4S Ltd. Study the exhibit carefully, router P4S-RA is the hub router in a Frame Relay hub-and-spoke deployment. Configure router P4S-RA's serial interface as a point-to-multipoint interface, and it is servicing three spoke routers. The link between Router P4S-RC and the frame provider experiences a service disruption, which causes the interface on Router P4S-RC to go down. How does Router P4S-RA learn of this failure in the network and how does it react?



  1. If OAM is configured between Router P4S-RA and Router P4S-RC, router P4S-RA will be notified of the failure after three missed OAM packets. After the third OAM packet is missed, the frame PVC becomes inactive, and this event terminates the routing process neighbor relationship established between Router P4S-RA and Router P4S-RC.
  2. Router P4S-RA does not detect the failure in the network and its interface continues to remain in an operational state. If routing is configured over this link, Router P4S-RA must wait for the neighbor relationship to time-out before updating its routing table to account for the lost router and its networks.
  3. Router P4S-RA must wait for a full LMI status update from the provider frame switch before it is notified about the PVC status. Once the full LMI status message is received, the routing process neighbor relationship between Router P4S-RA and Router P4S-RC is immediately terminated.
  4. Router P4S-RA immediately detects the failure via LMI notification and its interface is placed in a non-operational state. If routing is configured over this link, the neighbor relationship is terminated and the routing table is updated. The change is then propagated as appropriate to the rest of the network.

Answer(s): B






Post your Comments and Discuss Cisco® 351-001 exam with other Community members:

351-001 Discussions & Posts