Free 642-188 Exam braindumps download (642-188 exam dumps Free)

QUESTION: 31

When performing the Auto White Balance Adjustment on a Cisco Telepresence System, Which three statements are correct? (Choose three)

Lights must be set as they would be during a TelePresence meeting
The RJ-45 cables must be unplugged from the C3meras not being configured to ensure that each camera is set up independency
Ensure that no movement in the room might cross in front of the camera or create shadows on the target board
Target boards should be set up on each table segment at the same time. The adjustment runs on all segments at the same time to capture the exact lighting for a consistent configuration
The adjustment must be run on each segment and can be run only one segment at a time
The adjustment needs to be run only on the center camera. The settings are duplicated on the left and right segments

Answer(s): A,C,E

Show Answer Next Question

During your assessment of a potential Cisco Telepresence System 1300 room you notice.

• None of the insulated walls extend up to the structural deck above the suspended ceiling tiles
• All adjacent rooms are conference rooms

The customer makes it clear that their landlord prohibits wall construction in the open plenum space above the suspended ceiling.
What are two appropriate recommendations? (Choose two)

Recommend the customer doubles the layer of drywall below the plenum ceiling to achieve adequate isolation from adjacent room
Recommend the customer installs white noise generator to mask the noise from adjacent rooms
Recommend the customer installs added insulation above the suspended ceiling tiles
Recommend the customer do noth.ng but be advised of possible no.se issues with the adjacent rooms so that proper expectation is

Answer(s): A,C

Show Answer Next Question

QUESTION: 33

Which side of the cabinet is the Cisco Telepresence System 1100 and 1300 codec inserted?

right
center
left
back and center

Answer(s): A

Show Answer Next Question

QUESTION: 34

How many camera processors does the Cisco Telepresence System 1300 have?

one
two
three
four

Answer(s): C

Show Answer Next Question

QUESTION: 35

How should directory number of the phone and the Cisco Telepresence endpoint be configured in the Cisco Unified CallManager?

As a shared line where the codec and IP phone share the same directory number
As a single line for the codec and a single line for the phone using the same directory number.
As an overlay line using the same directory number
As a single line for the phone and it only has a directory phone number. The codec uses the IP address of the phone

Answer(s): A

Show Answer Next Question

Free 642-188 Exam Braindumps
642-188 Implementing Cisco Telepresence Installations Questions 31–35 (page: 8)

QUESTION: 31

QUESTION: 32

QUESTION: 33

QUESTION: 34

QUESTION: 35

Free 642-188 Exam Braindumps 642-188 Implementing Cisco Telepresence Installations Questions 31–35 (page: 8)

QUESTION: 31

QUESTION: 32

QUESTION: 33

QUESTION: 34

QUESTION: 35

Free 642-188 Exam Braindumps
642-188 Implementing Cisco Telepresence Installations Questions 31–35 (page: 8)