CompTIA N10-009 Exam Questions
CompTIA Network+ (Page 12 )

Updated On: 12-Apr-2026

An IT manager needs to connect ten sites in a mesh network. Each needs to be secured with reduced provisioning time.
Which of the following technologies will best meet this requirement?

  1. SD-WAN
  2. VXLAN
  3. VPN
  4. NFV

Answer(s): A



Which of the following is most likely responsible for the security and handling of personal data in Europe?

  1. GDPR
  2. SCADA
  3. SAML
  4. PCI DSS

Answer(s): A



An organization has a security requirement that all network connections can be traced back to a user. A network administrator needs to identify a solution to implement on the wireless network.
Which of the following is the best solution?

  1. Implementing enterprise authentication
  2. Requiring the use of PSKs
  3. Configuring a captive portal for users
  4. Enforcing wired equivalent protection

Answer(s): A



A customer is adding fiber connectivity between adjacent buildings. A technician terminates the multimode cable to the fiber patch panel. After the technician connects the fiber patch cable, the indicator light does not tum on.
Which of the following should a technician try first to troubleshoot this issue?

  1. Reverse the fibers.
  2. Reterminate the fibers.
  3. Verify the fiber size.
  4. Examine the cable runs for visual faults.

Answer(s): A



Users cannot connect to an internal website with an IP address 10.249.3.76. A network administrator runs a command and receives the following output:

Which of the following command-line tools is the network administrator using?

  1. tracert
  2. netstat
  3. tcpdump
  4. nmap

Answer(s): A



After running a Cat 8 cable using passthrough plugs, an electrician notices that connected cables are experiencing a lot of cross talk.
Which of the following troubleshooting steps should the electrician take first?

  1. Inspect the connectors for any wires that are touching or exposed.
  2. Restore default settings on the connected devices.
  3. Terminate the connections again.
  4. Check for radio frequency interference in the area.

Answer(s): A



A technician is troubleshooting a user's laptop that is unable to connect to a corporate server. The technician thinks the issue pertains to routing.
Which of the following commands should the technician use to identify the issue?

  1. tcpdump
  2. dig
  3. tracert
  4. arp

Answer(s): C



After installing a series of Cat 8 keystones, a data center architect notices higher than normal interference during tests.
Which of the following steps should the architect take to troubleshoot the issue?

  1. Check to see if the end connections were wrapped in copper tape before terminating.
  2. Use passthrough modular crimping plugs instead of traditional crimping plugs.
  3. Connect the RX/TX wires to different pins.
  4. Run a speed test on a device that can only achieve 100Mbps speeds.

Answer(s): A



Viewing page 12 of 75
Viewing questions 89 - 96 out of 619 questions



Post your Comments and Discuss CompTIA N10-009 exam dumps with other Community members:

N10-009 Exam Discussions & Posts

AI Tutor AI Tutor 👋 I’m here to help!