Free PW0-100 Exam Braindumps (page: 67)

Page 67 of 151

Which of the following items is NOT necessary to document as part of a long-distance RF path survey?

  1. Antenna location at end of the link
  2. Seasonal changes in the environment
  3. All current and future path obstructions
  4. Whether the link is over water or land
  5. Air traffic landing zones

Answer(s): E

Explanation:

There are many outdoor interference sources, and some can change just by their nature.
Seek out and record the effects of the following:
1. Trees, buildings, lakes, or other obstructions or reflective objects
2. Trees without leaves that will later have leaves or that will grow to interfere with the Fresnel zone.
3. Automobile traffic - if linking two buildings at first-story height across a road, a large truck or bus could disable the link.
Record the interference source, its location, and its effect and potential effect on wireless LAN coverage, range, and throughput. This data should be recorded both on your copy of the blueprint as well as in a separate list for easy future reference. Taking pictures of interference sources that are permanent (e.g., lakes and buildings) will serve as a visual reference to the client.



While performing an RF site survey for an 802.11b Wireless LAN, what minimum bandwidth setting should you use?

  1. It will be based on throughput requirements
  2. Always use 1 Mbps
  3. No minimum bandwidth settings are required.
  4. Always use 11 Mbps

Answer(s): D

Explanation:

If you are using an 802.11b wireless LAN, for example, record where the data rate decreases from 11Mbps to 5.5Mbps to 2Mbps to 1Mbps, as shown in Figure 11.16. These boundaries should somewhat resemble concentric circles, with the slower data rate areas further from the access point than the higher data rates. The client organization must be told that when a user roams out past the coffee machine to the mailroom, that user will not get the highest possible throughput due to the data rate decrease, which, in turn, is due to the distance increase.




What is the name for a group of wireless stations communicating without the use of an access point?

  1. Client mode
  2. Client Peer mode
  3. Infrastructure mode
  4. Basic Service Set
  5. Independent Basic Service Set

Answer(s): E



When comparing omni-directional antennas with antennas that focus the signal into a narrow beam, which of the following attributes is higher for narrow beam antennas?

  1. Noise reception
  2. kfactor
  3. Gain
  4. Down tilt angle
  5. Wind loading

Answer(s): C



Page 67 of 151



Post your Comments and Discuss CWNP PW0-100 exam with other Community members:

willianzd@terra.com.br commented on October 16, 2014
Preciso do desconto para EW0-300, Cisco CCNA, Huawei HCNA. ITIL entre outros...
UNITED STATES
upvote

Ridhi commented on June 22, 2013
Myfeedback about HP0-064. EXCELLENT... I pass. Very Excellent
GTA
upvote

Taylor G commented on June 22, 2013
The good news is I passed the exam!
Dijon
upvote

Ridhi commented on April 20, 2009
Myfeedback about HP0-064. EXCELLENT... I pass. Very Excellent
GTA
upvote

Taylor G commented on April 18, 2009
The good news is I passed the exam!
Dijon
upvote