Free PW0-100 Exam Braindumps (page: 84)

Page 84 of 151

Focusing the antenna lobe in a desired direction caused an increase in the distance a propagated RF wave will travel. What term defines this effect?

  1. Extension
  2. Active Amplification
  3. Beam Narrowing
  4. Passive Gain

Answer(s): D

Explanation:

Antennas have passive gain, which means they do not increase the power that is input into them, but rather shape the radiation field to lengthen or shorten the distance the propagated wave will travel. The higher the antenna gain, the farther the wave will travel, concentrating its output wave more tightly so that more of the power is delivered to the destination (the receiving antenna) at long distances.


Reference:

CWNA Official Study Guide, Page 142



What is the VSWR value that indicates a perfect impedance match between an antenna and the attached cable?

  1. 0:0
  2. 1:1
  3. 10:1
  4. 0:1

Answer(s): B

Explanation:

VSWR is a ratio, so it is expressed as a relationship between two numbers. A typical VSWR value would be 1.5:1. The two numbers relate the ratio of impedance mismatch against a perfect impedance match. The second number is always 1, representing the perfect match, where as the first number varies. The lower the first number (closer to 1), the better impedance matching your system has. For example, a VSWR of 1.1:1 is better than 1.4:1. A VSWR measurement of 1:1 would denote a perfect impedance match and no voltage standing wave would be present in the signal path.


Reference:

CWNA Official Study Guide, Page 53



What organization currently creates wireless LAN operational standards?

  1. IEEE
  2. WLANA
  3. Wi-Fi Alliance
  4. WLIF

Answer(s): A

Explanation:

It is the job of the IEEE to create standards of operation within the confines of the regulations created by the FCC. The IEEE and OpenAir standards regarding FHSS systems describe:
1. what frequency bands may be used
2. hop sequences
3. dwell times
4. data rates


Reference:

CWNA Official Study Guide, Page 80



Which of the following conversions may be necessary when performing wireless LAN mathematical calculations?

  1. dBm to milliwatts
  2. dBi to milliwatts
  3. dB to watts
  4. dBm to dBi

Answer(s): A

Explanation:

This equation can be manipulated to reverse the conversion, now converting dBm to mW:

Most of the power levels referred to by administrators will be in mW or dBm. These two units of measurement both represent an absolute amount of power and are both industry standard measurements.


Reference:

CWNA Official Study Guide, Page 61



Page 84 of 151



Post your Comments and Discuss CWNP PW0-100 exam with other Community members:

willianzd@terra.com.br commented on October 16, 2014
Preciso do desconto para EW0-300, Cisco CCNA, Huawei HCNA. ITIL entre outros...
UNITED STATES
upvote

Ridhi commented on June 22, 2013
Myfeedback about HP0-064. EXCELLENT... I pass. Very Excellent
GTA
upvote

Taylor G commented on June 22, 2013
The good news is I passed the exam!
Dijon
upvote

Ridhi commented on April 20, 2009
Myfeedback about HP0-064. EXCELLENT... I pass. Very Excellent
GTA
upvote

Taylor G commented on April 18, 2009
The good news is I passed the exam!
Dijon
upvote