QUESTION: 13

A technician in Portland, Oregon has been asked to update the firmware on a server in Omaha, Nebrask

They will use an NFS server also located in Nebraska for serving patches that have been vetted by their security teams.
What two pieces of information does the technician need in order to access the NFS patch server from the Lifecycle Controller or iDRAC? (Choose two.)
Username and password
CHAP authentication credentials
IP address or hostname
Share name

Answer(s): A,D

QUESTION: 14

A technician wants to move memory from a few older system into a newer system.
What is the most efficient method for the technician to accomplish this task?

Back up the server profile on the older server, move the matching memory, and import the server profile to the new server
Use iDRAC to view the memory details of the older systems. Power down the servers to move matching memory to the new server
Power down any of the older servers to move any memory to the new server, update BIOS to allow mis-matched memory.
Power down all of the older servers to physically check the memory. Move any matching memory to the new server.

Answer(s): C

Reveal Solution Next Question

A technician has a server with the following memory configuration:
· Sixteen 4 GB dual-rank DIMMs
· 48 GB available to the OS
The workload intended for the server required the memory configuration to protect against some errors. Now the technician must deploy for a different workload that requires access to all available memory.
Which setting should the technician change to make all memory available to the system?

Mirrored
Optimizer
Performance
Sparing

Answer(s): A

Reveal Solution Next Question

QUESTION: 16

A technician installs a server with a network daughter card (NDC). The NDC has two 10Gb BaseT ports as well as 1Gb BaseT ports. The technician is using the correct CAT-6 network cable and a 10Gb switch.
The server reports 1Gb connections on ports 3 and 4. Ports 1 and 2 are down.
How should the technician get 10Gb connectivity?

Replace the network cables
Hard set the switch ports to 10Gb
Move the cables over to ports 1 and 2
Use different ports on the switch

Answer(s): D

Reveal Solution Next Question

Free DCAPE-100 Exam Braindumps (page: 4)

QUESTION: 13

QUESTION: 14

QUESTION: 15

QUESTION: 16