Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Dell
  5. DCAPE-100

Dell DCAPE-100 Exam
Dell PowerEdge Associate Exam (Page 2 )

Updated On: 1-Feb-2026
Page 2 of 12
PDF with 55 Questions

A technician builds a bootable ISO with Repository Manager, and then mounts the ISO via the iDRAC virtual console. After the updates have completed, the technician reboots the server to apply the updates.
When reviewing the updates, the technician determines NOT all updates were applied.
What is causing this issue?

  1. The iDRAC update caused virtual media disconnect.
  2. A SUU repository must be used to update the firmware instead of the bootable ISO.
  3. An OS was NOT installed prior to upgrading the firmware.
  4. The firmware must be manually updated from the iDRAC.

Answer(s): D



A technician needs to initially configure a server from a bare metal condition in the following areas:
· Processor settings
· Disk configuration
· iDRAC network settings
The technician can only reboot once to achieve these tasks.
Where should the technician configure these settings? (Choose three.)

  1. PXE Settings
  2. System BIOS
  3. PERC Configuration Utility
  4. iDRAC Settings
  5. Device Settings

Answer(s): A,B,C



A technician needs to troubleshoot a server. The OS was operational. After an untrained person accesses the System Setup utility on the server, the OS now fails to load. The technician reboots the server, selects F2, accesses the System Setup utility, and selects System

BIOS.
The technician needs to verify items in the System BIOS settings before reloading the OS.
Which two items should the technician verify? (Choose two.)

  1. Boot Settings > Boot Option Settings > Boot Sequence
  2. Device Settings > Boot Sequence
  3. Integrated Devices > OS Watchdog Timer
  4. Boot Settings > Boot Mode

Answer(s): C,D



Which operation should a technician perform to ensure configuration recovery if a server must be physically replaced?

  1. View and export the current hardware inventory
  2. Create and export a Server Configuration Profile
  3. Back up and export the Server Profile to a network share
  4. Back up the Server Profile to vFlash

Answer(s): D



A server arrives without any RAID configuration. All firmware is up to date. The server has a PERC H730p controller. The technician needs to configure the required RAID arrays prior to OS installation.
Which three methods can be used to configure the RAID arrays? (Choose three.)

  1. Boot into the Ctrl+C
  2. Access the Physical Disk section of the iDRAC GUI
  3. Access the Virtual Disk section of the iDRAC GUI
  4. Boot into the Ctrl+R
  5. Boot into the F2 BIOS

Answer(s): C,D,E



Viewing page 2 of 12
Viewing questions 6 - 10 out of 55 questions



Post your Comments and Discuss Dell DCAPE-100 exam prep with other Community members:

Join the DCAPE-100 Discussion