QUESTION: 13

Refer to the exhibit.

Which configuration will allow S1 to ping S2’s Lo0 address?

S1(config-router)# ip route 144.254.32.1 192.168.32.2/32
S1(config-router)# ip route 192.168.32.2 144.254.32.1/32
S1(config)# ip route 144.254.32.1/32 192.168.32.2
S1(config)# ip route 192.168.32.2 144.254.32.1/32

Answer(s): C

QUESTION: 14

The network administrator wants to configure RADIUS authentication for VTY access, and for console access to use the local configuration. Which two commands should be used to achieve this goal?

aaa authentication login vty group radius
aaa authentication login console local
aaa authentication login default group radius
aaa authentication login console local
aaa authentication login vty radius
aaa authentication login console group local
aaa authentication login default group radius
aaa authentication login console group local

Answer(s): B

Reveal Solution Next Question

There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error message is generated. What is the correct action to resolve the issue?

Verify the VLT LAG ID is configured correctly on both VLT peers.
Enable RSTP on both VLT peers.
Use the show VLT detail and show VLT brief commands to view the VLT port channel status information.
Perform a mismatch check after the VLT peer is established.

Answer(s): D

Reference:

https://www.dell.com/support/manuals/us/en/04/poweredge-fx2/dell%20fn%20ioa%20config_9.8.0.0_pub-v1/troubleshooting-vlt?guid=guid-9978ac1f-1305-4590-9c64-bb35bd6e012a&lang=en-us

Reveal Solution Next Question