QUESTION: 25

A site wishes to perform source address translation on packets arriving from the Internet for clients using some pools but not others. The determination is not based on the client's IP address, but on the pool they are load balanced to. What could best accomplish this goal?

A SNAT for all addresses could be defined, and then disable the SNAT processing for select pools.
The decision to perform source address translation is always based on VLAN. Thus, the goal cannot be achieved.
For each virtual server, regardless their default load balancing pools, association with SNAT pools could vary dependent upon need.
The decision to perform source address translation is always based on a client's address (or network). Thus, this goal cannot be achieved.

Answer(s): A

Reveal Solution Next Question

QUESTION: 26

Which two statements are true about SNATs? (Choose two.)

SNATs are enabled on all VLANs, by default.
SNATs can be configured within a Profile definition.
SNATs can be configured within a Virtual Server definition.
SNAT's are enabled only on the VLAN where origin traffic arrives, by default

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 27

A BIG‐IP has two load balancing virtual servers at 150.150.10.10:80 and 150.150.10.10:443. The port 80 virtual server has SNAT automap configured. There is also a SNAT configured at 150.150.10.11 set for a source address range of 200.200.1.0 /255.255.255.0. All other settings are at their default states. If a client with the IP address 200.200.1.1 sends a request to https://150.150.10.10, what is the source IP address when the associated packet is sent to the pool member?

200.200.1.1
150.150.10.11
Floating self IP address on VLAN where the packet leaves the system
Floating self IP address on VLAN where the packet arrives on the system

Answer(s): B

Reveal Solution Next Question

QUESTION: 28

Which statement is true concerning SNATs using automap?

Only specified self‐IP addresses are used as automap addresses.
SNATs using automap will translate all client addresses to an automap address.
A SNAT using automap will preferentially use a floating self‐IP over a non‐floating self‐IP.
A SNAT using automap can be used to translate the source address of all outgoing traffic to the same address regardless of which VLAN the traffic is sent through.

Answer(s): C

Reveal Solution Next Question

Free 201 Exam Braindumps (page: 7)

QUESTION: 25

QUESTION: 26

QUESTION: 27

QUESTION: 28