Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. F5
  5. 301b

F5 301b Exam
BIG-IP Local Traffic Manager (LTM) Specialist: Maintain & Troubleshoot (Page 7 )

Updated On: 1-Feb-2026
Page 7 of 43
PDF with 210 Questions

A device group is made up of four members: LTM-A, LTM-B, LTM-C, and LTM-D. An LTM Specialist makes a configuration change on LTM-B. Later, a different LTM Specialist notices a "changes pending" message on all devices. When logged into LTM-D, the LTM Specialist attempts to config-sync to the device group. The sync operation fails.
Why is the LTM Specialist on LTM-D unable to synchronize the configuration to the group?

  1. The changes made on LTM-B are invalid.
  2. LTM-D has the lowest commit-id of the group.
  3. NTP is NOT configured on the devices in the group.
  4. LTM-B is the device eligible to initiate a config-sync.

Answer(s): D



An LTM Specialist configures two LTM devices in a high-availability pair with trusts established and device groups configured properly using network failover. After several months, the LTM Specialist notices that changes made to one LTM device do NOT cause the synchronization status to update to "changes pending, " and this device does NOT synchronize with the device group.
Which two steps should the LTM Specialist take to identify the issue? (Choose two.)

  1. Verify that NTP is synchronized.
  2. Verify the network connectivity between the devices.
  3. Verify that the devices are not using self-signed certificates.
  4. Verify that ConfigSync is using the management IP address.
  5. Verify that port lockdown on the ConfigSync interface is set to allow port 1026.

Answer(s): A,B



Which command should an LTM Specialist use on the command line interface to show the health of RAID array hard drives?

  1. tmsh show /sys raid disk
  2. tmsh show /ltm raid disk
  3. tmsh show /sys raid status
  4. tmsh show /ltm disk status

Answer(s): A



Which command line interface command will check if the BIG-IP platform contains a packet velocity ASIC (PVA)?

  1. bigpipe platform show | grep -i pva
  2. tmsh show /sys hardware pva status
  3. tmsh show /sys hardware | grep -i pva
  4. tmsh show /ltm hardware | grep -i pva

Answer(s): C



Which two subsystems could the LTM Specialist utilize to access an LTM device with lost management interface connectivity? (Choose two.)

  1. AOM
  2. ILO
  3. SCCP
  4. ALOM

Answer(s): A,C



Viewing page 7 of 43
Viewing questions 31 - 35 out of 210 questions



Post your Comments and Discuss F5 301b exam prep with other Community members:

Join the 301b Discussion