QUESTION: 9

If a client's browser does not accept cookies, what occurs when the client connects to a virtual server using cookie persistence?

The connection request is not processed.
The connection request is sent to an apology server.
The connection request is load-balanced to an available pool member.
The connection request is refused and the client is sent a "server not available" message.

Answer(s): C

Reveal Solution Next Question

QUESTION: 10

Assuming other fail-over settings are at their default state, what would occur if the fail-over cable were to be disconnected for five seconds and then reconnected?

As long as network communication is not lost, no change will occur.
Nothing. Fail-over due to loss of voltage will not occur if the voltage is lost for less than ten seconds.
When the cable is disconnected, both systems will become active.
When the voltage is restored, unit two will revert to standby mode.
When the cable is disconnected, both systems will become active.
When the voltage is restored, both systems will maintain active mode.

Answer(s): C

Reveal Solution Next Question

QUESTION: 11

Assuming there are open connections through an active system's virtual servers and a fail-over occurs, by default, what happens to the connections?

All open connections are lost.
All open connections are maintained.
When persistence mirroring is enabled, open connections are maintained even if a fail-over occurs.
Long-lived connections such as Telnet and FTP are maintained, but short-lived connections such as HTTP are lost.
All open connections are lost, but new connections are initiated by the newly active BIG-IP, resulting in minimal client downtime.

Answer(s): A

Reveal Solution Next Question

QUESTION: 12

Which VLANs must be enabled for a SNAT to perform as desired (translating only desired packets)?

The SNAT must be enabled for all VLANs.
The SNAT must be enabled for the VLANs where desired packets leave the BIG-IP.
The SNAT must be enabled for the VLANs where desired packets arrive on the BIG-IP.
The SNAT must be enabled for the VLANs where desired packets arrive and leave the BIG-IP.

Answer(s): C

Reveal Solution Next Question

Free F50-521 Exam Braindumps (page: 3)

QUESTION: 9

QUESTION: 10

QUESTION: 11

QUESTION: 12