QUESTION: 5

When a pool is created and saved to file, where is the default file and location for the pool configuration? When a pool is created and saved to file, where is the default file and location for the pool configuration?

/config/bigip.conf
/config/BigDdat
/etc/bigip_base.conf
/config/bigip_base.conf

Answer(s): A

Reveal Solution Next Question

QUESTION: 6

Which are immediate results of entering the following command: b pool PoolA { lb method predictive member 10.10.1.1:80 member 10.10.1.2:80 }

A new pool is available for association with any iRule or virtual server.
The /config/bigip.conf file is updated to include a definition for the pool named PoolA.
No changes will take place since the command is missing the monitor component for PoolA.
Requests sent to this BIG-IP system with a destination port of 80 are load-balanced between the members of PoolA.

Answer(s): A

Reveal Solution Next Question

QUESTION: 7

When defining a load-balancing pool using the command line, if the load-balancing method is not specified, what is the result

The default load-balancing method would be used.
The load-balancing method of the previous pool would be used.
The system would prompt the user for a load-balancing method.
An error would be displayed since no load-balancing method was specified.

Answer(s): A

Reveal Solution Next Question

QUESTION: 8

Given the following tmsh prompts and commands, which is correct syntax to create a pool?

root@bigipsystem(Active)(tmos.ltm.pool)# create pool1 members add { 172.16.20.1:80 }
root@bigipsystem(Active)(tmos.ltm.pool)# create pool pool1 members add { 172.16.20.1:80 }
root@bigipsystem(Active)(tmos.ltm.pool)# create pool pool1 members add { 172.16.20.1:80 { } }
root@bigipsystem(Active)(tmos.ltm.pool)# create pool pool1 members add { 172.16.20.1:80 { priority-group 2 } }

Answer(s): A

Reveal Solution Next Question

Free F50-532 Exam Braindumps (page: 3)

QUESTION: 5

QUESTION: 6

QUESTION: 7

QUESTION: 8

F50-532 Discussions & Posts