Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
Scrum
All Vendors
  2. Home
  3. Exams
  4. Fortinet
  5. FCP_FAZ_AD-7.4

Free FCP_FAZ_AD-7.4 Exam Braindumps (page: 4)

Page 3 of 44
PDF with 178 Questions

Refer to the exhibit.



Based on the partial outputs displayed, which devices can be members of a FortiAnalyzer Fabric?

  1. FortiAnalyzer1 and FortiAnalyzer3
  2. All devices listed can be members.
  3. FortiAnalyzer1 and FortiAnalyzer2
  4. FortiAnalyzer2 and FortiAnalyzer3

Answer(s): C

Explanation:

Based on the partial configuration output, the primary factor for determining which devices can be members of a FortiAnalyzer Fabric is the log-mode setting. Devices with the same log mode can be part of the same FortiAnalyzer Fabric.

FortiAnalyzer1: Log mode is set to collector.

FortiAnalyzer2: Log mode is set to collector.

FortiAnalyzer3: Log mode is set to analyzer.

Devices with the same log mode can be part of the same fabric. Since FortiAnalyzer1 and FortiAnalyzer2 both have their log modes set to collector, they can be members of a FortiAnalyzer Fabric.

Therefore, the correct answer is FortiAnalyzer1 and FortiAnalyzer2.



You finished registering a FortiGate device. After traffic starts to flow through FortiGate, you notice that only some of the logs expected are being received on FortiAnalyzer.

What could be the reason for the logs not arriving on FortiAnalyzer?

  1. FortiGate was added to the wrong ADOM type.
  2. This FortiGate model is not fully supported.
  3. FortiGate does not have logging configured correctly.
  4. This FortiGate is part of an HA cluster but it is the secondary device.

Answer(s): C

Explanation:

This issue can occur if FortiGate is not properly configured to send logs to FortiAnalyzer, such as incorrect logging settings or filters being applied that prevent certain logs from being sent. It's important to verify that logging is enabled on FortiGate and that the correct log settings (such as log severity or log type) are configured for transmission to FortiAnalyzer.



An administrator, fortinet, can view logs and perform device management tasks, such as adding and removing registered devices. However, administrator fortinet is not able to create a mail server that can be used to send alert emails.

What can be the problem?

  1. ADOM mode is configured with Advanced mode.
  2. A trusted host is configured.
  3. fortinet is assigned the default Standard_User administrative profile.
  4. fortinet is assigned the default Restricted_User administrative profile.

Answer(s): C

Explanation:

The Standard_User profile allows viewing logs and performing some device management tasks but typically does not allow configuring global settings like creating a mail server for alert emails. To create a mail server, the administrator would need to have a profile with higher privileges, such as Super_User or a custom profile with the necessary permissions.



Which two parameters are used to calculate the Total Quota value available on FortiAnalyzer? (Choose two.)

  1. Used storage
  2. Retention policy
  3. Reserved space
  4. Total system storage

Answer(s): C,D

Explanation:

The Total Quota is derived from the total system storage minus any reserved space allocated for system use, such as databases, system files, or reserved space for log retention policies. Used storage and retention policies do not directly impact the calculation of the quota available, though they can influence overall space utilization.






Post your Comments and Discuss Fortinet FCP_FAZ_AD-7.4 exam with other Community members: