Free NSE4_FGT-7.2 Exam Braindumps
Fortinet NSE 4 - FortiOS 7.2 Questions 46–50 (page: 11)

Updated On: 10-Feb-2026

Refer to the exhibit.





The exhibit contains the configuration for an SD-WAN Performance SLA, as well as the output of diagnose sys virtual-wan-link health-check .
Which interface will be selected as an outgoing interface?

  1. port2
  2. port4
  3. port3
  4. port1

Answer(s): D

Explanation:

Port 1 shows the lowest latency.



Refer to the exhibit.



Review the Intrusion Prevention System (IPS) profile signature settings.
Which statement is correct in adding the FTP.Login.Failed signature to the IPS sensor profile?

  1. The signature setting uses a custom rating threshold.
  2. The signature setting includes a group of other signatures.
  3. Traffic matching the signature will be allowed and logged.
  4. Traffic matching the signature will be silently dropped and logged.

Answer(s): D

Explanation:

Select Block to silently drop traffic matching any of the signatures included in the entry. So, while the default action would be 'Pass' for this signature the administrator is specifically overriding that to set the Block action. To use the default action the setting would have to be 'Default'.

Action is drop, signature default action is listed only in the signature, it would only match if action was set to default.



Refer to the exhibit.



The exhibit contains a network diagram, virtual IP, IP pool, and firewall policies configuration. The WAN (port1) interface has the IP address 10.200. 1. 1/24. The LAN (port3) interface has the IP address 10 .0.1.254. /24. The first firewall policy has NAT enabled using IP Pool. The second firewall policy is configured with a VIP as the destination address.
Which IP address will be used to source NAT the internet traffic coming from a workstation with the IP address 10.0. 1. 10?

  1. 10.200. 1. 1
  2. 10.200.3. 1
  3. 10.200. 1. 100
  4. 10.200. 1. 10

Answer(s): C

Explanation:

Policy 1 is applied on outbound (LAN-WAN) and policy 2 is applied on inbound (WAN-LAN). question is asking SNAT for outbound traffic so policy 1 will take place and NAT overload is in effect.



Refer to the exhibit.



An administrator has configured a performance SLA on FortiGate, which failed to generate any traffic.
Why is FortiGate not sending probes to 4.2.2.2 and 4.2.2.1 servers? (Choose two.)

  1. The Detection Mode setting is not set to Passive.
  2. Administrator didn't configure a gateway for the SD-WAN members, or configured gateway is not valid.
  3. The configured participants are not SD-WAN members.
  4. The Enable probe packets setting is not enabled.

Answer(s): B,D



Refer to the exhibit.



Which contains a session list output. Based on the information shown in the exhibit, which statement is true?

  1. Destination NAT is disabled in the firewall policy.
  2. One-to-one NAT IP pool is used in the firewall policy.
  3. Overload NAT IP pool is used in the firewall policy.
  4. Port block allocation IP pool is used in the firewall policy.

Answer(s): B

Explanation:

FortiGate_Security_6.4 page 155 . In one-to-one, PAT is not required.



Viewing page 11 of 36
Viewing questions 51 - 55 out of 174 questions


Post your Comments and Discuss Fortinet NSE4_FGT-7.2 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!