CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. Fortinet
  5. NSE6_FSW-7.2

Free NSE6_FSW-7.2 Exam Braindumps (page: 1)

Page 1 of 15
PDF with 56 Questions

Refer to the diagnostic output:



Two entries in the exhibit show that the same MAC address has been used in two different VLANs.
Which MAC address is shown in the above output?

  1. It is a MAC address of FortiLink interface on FortiGate.
  2. It is a MAC address of a switch that accepts multiple VLANs.
  3. It is a MAC address of an upstream FortiSwitch.
  4. It is a MAC address of FortiGate in HA configuration.

Answer(s): B



Refer to the exhibit.



Core-1 and Access-1 are managed and authorized by FortiGate-1. which uses port4 as the FortiLink interface. After FortiGate authorizes and manages Core-2. Port1 status becomes STP discarding.
Why is port1 in the discarding state?

  1. port1 on Core-2 is discarding only management traffic.
  2. Core-1 and Core-2 do not have MCLAG configuration.
  3. Access-1 is the root bridge and can only have one root port.
  4. Core-2 has the lowest bridge priority.

Answer(s): B



Which two statements about the FortiLink authorization process are true? (Choose two.)

  1. The administrator must manually pre-authorize FortiGate on FortiSwitch by adding the FortiGate serial number.
  2. FortiSwitch requires a reboot to complete the authorization process.
  3. A FortiLink frame is sent by FortiGate to FortiSwitch to complete the authorization.
  4. FortiLink authorization sets the FortiSwitch management mode to FortiLink.

Answer(s): C,D



Refer to the exhibits





Traffic arriving on port2 on FortiSwitch is tagged with VLAN ID 10 and destined for PC1 connected on port1. PC1 expects to receive traffic untagged from port1 on FortiSwitch.
Which two configurations can you perform on FortiSwitch to ensure PC1 receives untagged traffic on port1? (Choose two.)

  1. Add the MAC address of PCI as a member of VLAN 10.
  2. Add VLAN ID 10 as a member of the untagged VLANs on port1.
  3. Remove VLAN 10 from the allowed VLANs and add it to untagged VLANs on port1.
  4. Enable Private VLAN on VLAN 10 and add VLAN 20 as an isolated VLAN.

Answer(s): A,B



Page 1 of 15



Post your Comments and Discuss Fortinet NSE6_FSW-7.2 exam with other Community members:

Philippe commented on September 18, 2024
Hi. The dump is valid ?
Anonymous
upvote

John commented on August 12, 2024
To those who are planning to set for this exam. I must say you need to study hard and go over all the content of this study guide. Otherwise you will not be able to pass.
UNITED STATES
upvote

David commented on August 07, 2024
Hi. The dump is valid ?
SPAIN
upvote