QUESTION: 21

Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?

type must be set to static.
mode-cfg must be enabled.
exchange-interface-ip must be enabled.
add-route must be disabled.

Answer(s): D

Reveal Solution Next Question

QUESTION: 22

Which are two benefits of using CLI templates in FortiManager? (Choose two.)

You can reference meta fields.
You can configure interfaces as SD-WAN members without having to remove references first.
You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
You can configure advanced CLI settings.

Answer(s): A,D

Reveal Solution Next Question

QUESTION: 23

Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

Each BGP route is three hops away from the destination.
ibgp-multipath is disabled.
additional-path is enabled.
You can run the get router info routing-table database command to display the additional paths.

Answer(s): C,D

Reveal Solution Next Question

QUESTION: 24

Refer to the exhibit.

Based on the exhibit, which action does FortiGate take?

FortiGate bounces port5 after it detects all SD-WAN members as dead.
FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.
FortiGate brings up port5 after it detects all SD-WAN members as alive.
FortiGate brings down port5 after it detects all SD-WAN members as dead.

Answer(s): B

Reveal Solution Next Question

Free NSE7_SDW-7.2 Exam Braindumps (page: 6)

QUESTION: 21

QUESTION: 22

QUESTION: 23

QUESTION: 24