QUESTION: 17

You cannot ping the FortiGate default gateway 10.10.10.1 from the FortiGate CLI. The FortiGate interface facing the default gateway is wan1 and its IP address is 10.10.10.254/24. During the initial troubleshooting tests, you confirm that you can ping other IP addresses in the 10.10.10.0/24 subnet from the FortiGate CLI without packets lost.

Which two CLI commands will help you to troubleshoot this problem? (Choose two.)

diagnose debug flow filter saddr 10.10.10.1
diagnose debug flow trace start 10
diagnose hardware deviceinfo nic wan1
diagnose ip arp list
diag sniffer packet wan1 'arp and host 10.10.10.1'

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 18

An organization has one central site and three remote sites. A FortiSIEM has been installed on the central site and now all devices across the remote sites must be centrally monitored by the FortiSIEM at the central site.

Which action will reduce the WAN usage by the monitoring system?

Enable SD-WAN FEC (Forward Error Correction) on the FortiGate at the remote site.
Install both Supervisor and Collector on each remote site.
Install local Collectors on each remote site.
Install local Collectors on each remote site.

Answer(s): C

Reveal Solution Next Question

QUESTION: 19

A customer is looking for a way to remove javascripts, macros and hyperlinks from documents traversing the network without affecting the integrity of the content. You propose to use the Content disarm and reconstruction (CDR) feature of the FortiGate.

Which two considerations are valid to implement CDR in this scenario? (Choose two.)

The inspection mode of the FortiGate is not relevant for CDR to operate.
CDR is supported on HTTPS, SMTPS, and IMAPS if deep inspection is enabled.
CDR can only be performed on Microsoft Office Document and PDF files.
Files processed by CDR can have the original copy quarantined on the FortiGate.

Answer(s): C,D

Reveal Solution Next Question

QUESTION: 20

Refer to the exhibit.

As shown in the exhibit, a FortiADC is load-balancing IPv4 traffic between two next-hop routers. The FortiADC does not know the IP addresses of the servers. Also, the FortiADC is doing Layer 7 content inspection and modification.

In this scenario, which application delivery control is configured in the FortiADC?

Layer 3
Layer 4
Layer 7
Layer 2

Answer(s): D

Reveal Solution Next Question

Free NSE8_811 Exam Braindumps (page: 5)

QUESTION: 17

QUESTION: 18

QUESTION: 19

QUESTION: 20