CompTIA
Checkpoint
ISC
HP
Dell
EC-Council
EXIN
Fortinet
ITIL®
Juniper
PMI
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
Certiport
ISC2
All Vendors
  2. Home
  3. Exams
  4. GAQM
  5. CLSSBB

Free CLSSBB Exam Braindumps (page: 12)

Page 12 of 65
PDF with 300 Questions

For the data set shown here which of these statements is/are true?

  1. Hypothesis Testing of Means or Medians cannot be done since there are an unequal number of observations for the 3 samples
  2. A Paired T-test would be applicable for comparing Grade B and Grade A since they follow each other in the data set
  3. Grade A has the lowest sample Mean of the 3 samples
  4. Grade A has a higher sample Mean than Grade B

Answer(s): C



Review the analysis shown here.



Which statements are true about the process? (Note: There are 3 correct answers).

  1. The initial focus for this project would be to determine why the thicknesses are so frequently too low.
  2. The majority of the process is closer to the lower specification limit.
  3. This process is described with the Weibull Distribution.
  4. The process has more problems with Variation than Centering.
  5. The process follows a non-normal distribution with the given data.

Answer(s): B,D,E



A Lean Six Sigma project is attempting to reduce inventory days. The Process Capability will be monitored as part of the Control Phase to track the sustainability of the improvement.



Which distribution type is best used for performing the Capability Analysis?

  1. Weibull Distribution
  2. Normal Distribution
  3. Exponential Distribution
  4. Logistic Distribution
  5. Gaussian Distribution

Answer(s): A



What conclusion is most correct about the Experimental Design shown here with the response in the far right column?

  1. No factor has enough statistical confidence greater than 95% to have an impact on the response rate
  2. Constant, Adv and Bev are the only factors statistically affecting the response rate with 95% confidence or more
  3. If the Adv is increased from the low level to the high level, the response rate increases
  4. The response level is statistically concluded to only need the Adv and Bev factors set at the low level to get the largest response rate
  5. This design does not have enough experimental runs to conclude anything as evidenced by the lack of P-values in the MINITABTM output

Answer(s): D



Page 12 of 65



Post your Comments and Discuss GAQM CLSSBB exam with other Community members:

António commented on April 03, 2024
Preparing for the exam. Great resource
PORTUGAL
upvote