Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
Microsoft
VMware
Avaya
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
MuleSoft
All Vendors
  2. Home
  3. Exams
  4. HP
  5. HPE2-T37

Free HPE2-T37 Exam Braindumps (page: 2)

Page 2 of 30
PDF with 115 Questions

Which statement about M-LAG setup is true?

  1. When combined with IRF, M-LAG will allow you to aggregate ports coming from clustered HPE Synergy Virtual Connect modules.
  2. M-LAG for HPE Synergy can be either single-homed or multi-homed, while for HPE BladeSystem only single-homed.
  3. sFLOW cannot be enabled if M-LAG is configured between HPE Synergy Virtual Connect modules in the same frame.
  4. M-LAG has to be defined manually for HPE BladeSystem, but it is automatically configured for HPE Synergy.

Answer(s): A



Which statement about a Logical Enclosure for HPE BladeSystem is Hue?

  1. A logical enclosure can have between 1 to 5 HPE BladeSystem c7000 enclosures.
  2. A logical enclosure must be created only for monitored HPE BladeSystem C700O enclosures.
  3. A logical enclosure is created automatically, and it is always based on a single enclosure.
  4. A logical enclosure can contain a mix of HPE BladeSystem c7000 and C3000 enclosures.

Answer(s): C



Refer to the exhibit.



Which statement about the logical interconnect shown is true?

  1. For FC uplink sets, an additional uplink from second module should be added for redundancy.
  2. The maximum supported number of the internal networks for logical interconnect is configured.
  3. Additional uplink ports can be added to ETH-Uplink to increase available bandwidth.
  4. FC uplinks are not supported and will be converted to FCoE or RoCE uplinks.

Answer(s): C



Refer to the exhibit.



Your customer wants to define a Logical Interconnect Group (UG) and set the redundancy of the master modules to highly available, but this option is not available.
What is a possible reason?

  1. There are not sufficient frames for highly available setup.
  2. Some master modules only support a redundant setup.
  3. Firmware on the master modules is too low to support highly available setup.
  4. A dedicated license must be added to HPE OneView to enable this feature.

Answer(s): B






Post your Comments and Discuss HP HPE2-T37 exam prep with other Community members: