support@Free-Braindumps.com
Register Login
Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
CrowdStrike
Anthropic
All Vendors
  1. Home
  2. Exams
  3. HP
  4. HPE2-Z39

Free HPE2-Z39 Exam Braindumps
Fast Track - Applying Aruba Switching Fundamentals for Mobility Questions 11–15 (page: 4)

Updated On: 10-Feb-2026
Page 4 of 14
PDF with 62 Questions

What is one characteristic of a spanning tree edge port on an ArubaOS switch?

  1. The port link state does not affect the RSTP topology.
  2. The port connects to a switch that runs MSTP but in a different region.
  3. The port only forwards traffic in VLANs assigned to the instance 0 (IST).
  4. The port ignores incoming BPDUs

Answer(s): B



A network administrator enters this command on an ArubaOS switch:
Switch(config) # trunk 1,2 trk1
What is required for the switch to combine both interfaces in a link aggregation?

  1. that the interfaces are up
  2. that the interfaces are aggregated while in a shutdown state
  3. that the interfaces are up and connect to interfaces that support active mode LACP
  4. that the interfaces are up and have LACP enabled on them

Answer(s): B





The switches shown in the exhibit are ArubaOS switches that implement RSTP. The switches are configured with the spanning tree priorities shown in the exhibit, and they use their default costs on ports. Based on the topology, which port is a root port?

  1. Switch A port 1
  2. Switch B port 2
  3. Switch C port 1
  4. Switch C port 2

Answer(s): B





What is the result of this configuration?

  1. The switch only adds the last static route entry to the routing table
  2. All four routes are added to the routing table, but are never used.
  3. The switch load shares connections across the four static next hops.
  4. The switch only adds the last two static route entries to the routing table.

Answer(s): B



What must the network administrator do to enable some traffic to flow over each switch-to-switch link?

  1. On Switch-3, assign STP priority 0 to instance 1 and STP priority 1 (4096) to instance 2. On Switch-4, assign STP priority 1 to instance 1 and STP priority 0 to instance 2.
  2. Change the STP mode to MSTP on each switch.
  3. Change the VLAN-to-instance mapping on half of the switches so that VLAN 2 is assigned to instance 1 and VLAN 3 is assigned to instance 1.
  4. Configure the same MSTP region name and revision number on each switch.

Answer(s): A



  PDF
Viewing page 4 of 14
Viewing questions 16 - 20 out of 62 questions


Post your Comments and Discuss HP HPE2-Z39 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!