HP HPE7-A01 Exam Prep
Aruba Certified Campus Access Professional (Page 17 )

Updated On: 21-Sep-2026

Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements. After the configuration was complete, it was noted that a user assigned with the administrator’s role did not have the appropriate level of access on the switch.
The user was not limited to viewing nonsensitive configuration information and a level of 1 was not assigned to their role.
Which default management role should have been assigned for the user?

  1. sysops
  2. auditors
  3. config
  4. operators

Answer(s): D

Explanation:

The operators role is the default management role in AOS-CX that provides read-only access, limiting the user to viewing nonsensitive configuration information without making changes. This matches the requirement and is appropriate when a user should not have full administrative or configuration privileges.



What is an OSPF transit network?

  1. a network that uses tunnels to connect two areas
  2. a network that connects to a different routing protocol
  3. a special network that connects two different areas
  4. a network on which a router discovers at least one neighbor

Answer(s): D

Explanation:

In OSPF, a transit network is any network segment (such as an Ethernet LAN) where at least two OSPF routers are present and can discover each other as neighbors, allowing the network to carry OSPF transit traffic.



Refer to the exhibit.

A company with 1,471 employees has deployed 200 AP-635 access points. To take advantage of the 6 GHz band, the administrator has attempted to configure a new WPA3-OWE SSID in the HPE Aruba Networking Central but is not working as expected.
What would be the correct action to fix the issue?

  1. Change the SSID to WPA3-Enhanced Open.
  2. Change the SSID to WPA3-Personal.
  3. Change the SSID to WPA3-Enterprise (CNSA).
  4. Change the SSID to WPA3-Enterprise (CCM).

Answer(s): A

Explanation:

On Aruba APs, WPA3-OWE is referenced as WPA3-Enhanced Open in the SSID security settings. To enable Opportunistic Wireless Encryption (OWE) for the 6 GHz band, configure the SSID as WPA3-Enhanced Open rather than just WPA3 or WPA3-Personal/Enterprise.



How do you allow a new VLAN 100 between VSX pair inter-switch-link 256 for port 1/45 and 2/45?

  1. vlan trunk add 100 in LAG256
  2. vlan trunk add 100 in MLAG256
  3. vlan trunk allowed 100 for ports 1/45 and 1/46
  4. vlan trunk allowed 100 in LAG256

Answer(s): D

Explanation:

To permit VLAN 100 across the VSX inter-switch link (ISL), you add it to the allowed VLANs on the LAG interface used for the ISL, which is typically LAG256 in Aruba VSX configurations.



When setting up an AOS-CX VSX pair, which information does the Inter-Switch Protocol synchronize in the configuration created?

  1. RPVST+
  2. SVI
  3. UDLD
  4. MSTP

Answer(s): D



Viewing page 17 of 34
Viewing questions 81 - 85 out of 161 questions


Post your Comments and Discuss HP HPE7-A01 exam prep with other Community members:

AI Tutor AI Tutor 👋 I’m here to help!