QUESTION: 145

A network administrator is planning to use an automatic 6to4 tunnel to transmit IPv6 network. If the IPv4 address of the router interface is 138.14.85.210, the corresponding tunnel address should be 2001:8a0e:55d2:1:230:65ff:fe2c:9a6.

TRUE
FALSE

Answer(s): B

Reveal Solution Next Question

QUESTION: 146

Two community filters are configured as follows:

ip community-filter 1 permit 100:1 200:1
ip community-filter 2 permit 100:1
ip community-filter 2 permit 200:1

Which of the following statements regarding the community filters are true? (Choose two.)

A BGP route matches community-filter 2 only when it carries the Community attribute values of 100:1 and 200:1.
A BGP route matches community-filter 1 only when it carries the Community attribute value of 100:1 or 200:1, or both.
A BGP route matches community-filter 1 only when it carries the Community attribute values of 100:1 and 200:1.
A BGP route matches community-filter 2 only when it carries the Community attribute values of 100:1 and 200:1, or both.

Answer(s): C,D

Reveal Solution Next Question

QUESTION: 147

Which of the following statements regarding RD filters are true? (Choose two.)

The relationship between the rules of an RD filter is “OR.”
If an RD filter is configured but the RD of routes does not match any RD defined in the RD filter, the default matching result is “permit.”
Routes are filtered according to the configuration order of multiple rules.
If an RD filter is not configured but used to filter routes, the matching result is “deny”.

Answer(s): A,C

Reference:

https://support.huawei.com/enterprise/en/doc/EDOC1000174046/26892fde/routing-policy-configuration-commands

Reveal Solution Next Question

QUESTION: 148

Which of the following statements is true regarding the domain authentication mode md5 hello command in the IS-IS process?

This command enables IS-IS Hello PDUs to carry authentication information.
IS-IS SNP and LSP can be flooded normally only when the domain authentication mode and password of all routers in the same routing domain are MD5 and hello.
IS-IS authentication cannot be applied to IPv6 environments.
Routing domain authentication enables Level-1 and Level-2 SNPs and LSPs to carry authentication information.

Answer(s): B

Reveal Solution Next Question

Free H12-261 Exam Braindumps (page: 37)

QUESTION: 145

QUESTION: 146

QUESTION: 147

Reference:

QUESTION: 148