QUESTION: 165

Based on the key configurations, as shown in the figure, R1 and R2 establish a Level-2 neighbor relationship. Which of the following statements regarding routing entries on R2 are true?

2020:: /64 will be displayed in the IP routing table.
2021:: /64 will be displayed in the IP routing table.
2019:: /64 will not be displayed in the IP routing table.
2022:: /64 will not be displayed in the IP routing table.

Answer(s): A

Reveal Solution Next Question

For Huawei S series switches, to control which member switch becomes the master switch of a stack, first power on the switch you wish to be the master switch, and then wait 20 seconds before powering on the other member switches.

TRUE
FALSE

Answer(s): A

Reference:

https://support.huawei.com/enterprise/en/doc/EDOC1000088745?section=j00b

Reveal Solution Next Question

QUESTION: 167

A network with the typology shown in the figure below is set up in a lab. On the network, SW1 uses the default configurations, and STP disables on SW2. Given this information, which of the following statements is true?

Go/0/2 of SW2 enters the Discarding state.
G0/0/1 of SW1 enters the Discarding state.
G0/0/1 of SW2 enters the Discarding state.
No interface is blocked.
G0/0/2 of SW1 enters the Discarding state.

Answer(s): E

Reveal Solution Next Question

QUESTION: 168

Huawei switches SWA and SWB are connected through seven physical Ethernet links and are configured with static link aggregation. On SWA, the interface and are configured in the following sequence: Ethernet 1/0/1, Ethernet 1/0/2, Ethernet 1/0/3, Ethernet 1/0/4, Ethernet 1/0/5, Ethernet 1/0/6,
Ethernet 1/0/7. If only six ports are supported in a LAG on SWA and SWB, which of the following statements is true?

If the configurations of different ports are consistent, SWA selects one of the seven ports at random to be the Unselected port of the LAG.
If the configurations of different ports are consistent, Ethernet 1/0/6 is the Unselected port of the LAG.
If the configurations of different ports are consistent, Ethernet 1/0/7 is the Unselected port of the LAG.
If the configurations of different ports are consistent, Ethernet 1/0/1 is the Unselected port of the LAG.

Answer(s): C

Reveal Solution Next Question

Free H12-261 Exam Braindumps (page: 42)

QUESTION: 165

QUESTION: 166

Reference:

QUESTION: 167

QUESTION: 168