QUESTION: 273

The following about the attribute BGP RD ( ) filter, is the description correct? (Multiple selection)

If configured, but the route does not match any of the specified RD-filter RD RD Permit rules, the default match is then recognized.
The use of the RD-filter ” configuration is the relationship between rules or
If there is no configuration, but reference RD-filter RD-filter deny, this is the filter line, the match is the result
Multiple, according to the configuration, the line matching rules

Answer(s): B,D

Reveal Solution Next Question

QUESTION: 274

ISIS DIS DIS ?( ) will access the election in the broadcast multiplex network. The following is correct.

ISIS DIS MAC is better than the first-ranked election. If it is consistent, it is better than the priority.
DIS CSNP is sent periodically to send messages to keep the data synchronization certificate
Accessing the network in a broadcast multiplex network, sending DIS Hello PDUs at a rate of three times
DIS DIS LSP support occupies the function, the new one occupies the success, does not need to flood any text

Answer(s): A,B,C

Reveal Solution Next Question

QUESTION: 275

What is correct about the following description? Filter-policy

In the middle, Filter-Policy, OSPF ASBR type 5 LSA type 7 LSA can be generated for filtering
The previous list can be used for both route suffix filtering and packet filtering.
Filter-Policy can receive or route the information line to filter the chain status, and modify the attributes of the route entry.
Pre-use list When route filtering is applied, the entry ip ip-prefix 1 deny 0.0.0.0 0 less-equal 32 means that only the default route is matched.

Answer(s): A

Reveal Solution Next Question

QUESTION: 276

OSPFv3 OSPFv2 OSPFv3 protocol Single-issue protocol is a separate one. It differs from the other in terms of road-based rather than network segment chain.
The next thing is to say the mistake?

Two routers connected to the link, even if their IPv6 addresses are differently suffixed, they can still establish a neighbor relationship.
Pairing the two routers connected to the road, even if you do not configure the broadcast IPv6 address, you can establish a neighbor.
The OSPFv3 Link-local router obtains the next hop of the neighboring address from the neighboring routing information.
In addition to the virtual connection, all interfaces use the address of the address composition OSPFv3 Link-local

Answer(s): D

Reveal Solution Next Question

Free H12-261 Exam Braindumps (page: 69)

QUESTION: 273

QUESTION: 274

QUESTION: 275

QUESTION: 276