Cisco®
CompTIA
Checkpoint
ISC
EC-Council
EXIN
Fortinet
ITIL®
Juniper
Microsoft
VMware
Avaya
SAP
Google
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk®
All Vendors
  2. Home
  3. Exams
  4. Huawei
  5. H12-261

Free Huawei H12-261 Exam Braindumps (page: 47)

Page 18 of 122
PDF with 483 Questions

Which of the following statements regarding LACP are true?

  1. You can run the following commands to delete member interfaces from an Eth-Trunk:
    interface GigabitEthernet0/0/1
    shutdown
    interface GigabitEthernet0/0/1
    undo eth-trunk 1
    interface GigabitEthernet0/0/1
    undo shutdown
  2. You can run the following commands to prevent frequent flapping due to physical link faults on an Eth-Trunk:
    interface eth-trunk 1
    lacp preempt enable
    lacp preempt delay delay-time
  3. You can run the following commands to add member interfaces to an Eth-Trunk:
    interface GigabitEthernet0/0/1
    shutdown
    interface eth-trunk 1
    trunkport GigabitEthernet0/0/1
    interface GigabitEthernet0/0/1
    undo shutdown
  4. You can run the following commands to enable load balancing based on source IP addresses for an Eth-Trunk:
    interface eth-trunk 1
    load-balance src-dst-ip

Answer(s): A



Which of the following statements regarding PPPoE data frames are true?

  1. The Ethernet_Type field has a fixed value of 0x8863.
  2. The Session_ID field of a PPP session must be the value specified in the Discovery phase and cannot be changed.
  3. When PPPoE is used to transmit session data, Code must be set to 0x0.
  4. After a PPPoE session is set up, all Ethernet packets are unicast.

Answer(s): B



As shown in the figure below, R1 and R2 are connected through a PPP link, and the IP addresses on the directly connected interfaces are not on the same network segment. R1 and R2 can communicate with each other through the directly connected interfaces. However, communication on the Ethernet link fails if the IP addresses on the directly connected interfaces are on the same network segment. What are the causes of this?

  1. The Ethernet header does not need to be encapsulated into data packets between R1 and R2 that are directly connected through a POS interface, and ARP does not need be used to obtain MAC addresses.
  2. R1 and R2 that are directly connected through a POS interface learn the MAC address of each other using LCP, and ARP does not need to be used to obtain MAC addresses.
  3. R1 and R2 that are directly connected through a POS interface learn the 24-bit subnet route of each other through IPCP.
  4. R1 and R2 that are directly connected through a POS interface learn the 32-bit host route of each other through IPCP.

Answer(s): D



Routes received from AS100 match the AS-Path filter configured using the ip as-path-filter 10 permit_100$ command.

  1. TRUE
  2. FALSE

Answer(s): A






Post your Comments and Discuss Huawei H12-261 exam prep with other Community members:

H12-261 Exam Discussions & Posts