QUESTION: 145

If it is turned on on the switch PoE The function of this, you can no longer access traditional equipment on these interfaces.

True
False

Answer(s): B

Reveal Solution Next Question

QUESTION: 146

Each AC Equipment needs to be specified AC The source of IP Address for peace AP Establish

CAPWAP Tunnel, one AC You can specify up to 2 Piece WLAN source IP.

True
False

Answer(s): B

Reveal Solution Next Question

According to the following configuration example, the following statement is correct ().
[AC] dhcp enable
[AC] interface VLANif100
[AC-VLANif100] ip address 10.1.100.1 24
[AC-VLANif100] dhcp select interface
[AC-VLANif100] quit

The DHCP service is already enabled by default in the global mode, so dhcp enable does not need to be configured
The dhcp select interface command is to enable the DHCP client function on the VLAN 100 interface
If VLAN100 is a user VLAN, after the user receives the address, the gateway is 10.1.100.1 and the mask is 255.255.255.0
If VLAN100 is the management VLAN where the AP is located, the option 43 field in the DHCP message that the AP will receive should be 10.1.100.1

Answer(s): C

Reveal Solution Next Question

QUESTION: 148

If you don't configure it, AP Which default authentication method is supported ()?

mac-auth
sn-auth
no-auth
mac-sn-auth

Answer(s): A

Reveal Solution Next Question

Free H12-311_V3.0 Exam Braindumps (page: 37)

QUESTION: 145

QUESTION: 146

QUESTION: 147

QUESTION: 148