Cisco
CompTIA
ISC
EC-Council
EXIN
Fortinet
ITIL
Juniper
Microsoft
VMware
Avaya
SAP
Google
NVIDIA
Salesforce
Amazon
Palo Alto Networks
ISC2
Splunk
ServiceNow
All Vendors
  2. Home
  3. Exams
  4. Huawei
  5. H12-322

Huawei H12-322 Exam Questions
Huawei Certified ICT Professional - Wireless Local Area Network- Planning and Optimizing Enterprise WLAN (Page 10 )

Updated On: 21-Feb-2026
Page 10 of 58
PDF with 282 Questions

During the establishment of the dual-link backup active/standby CAPWAP tunnel, which of the following parameters should be included in the Discover Response sent by the active and standby ACs?

  1. Dual link characteristic switch
  2. IP and priority of the respective AC
  3. Load status of each AC
  4. Configuration files of the respective ACs
  5. Forwarding mode of each service set of AC

Answer(s): A,B,C



The following is a statement about the WLAN room sub-channel planning. What is wrong?

  1. Confirm the local available channel with the customer before planning
  2. The same channel is the same as the channel sent by the antenna connected to the AP.
  3. Huawei's room AP6310 supports channel planning for 2.4G and 5G bands simultaneously.
  4. Adjacent edge antennas do not use the same channel

Answer(s): C



Which of the following devices has an internal antenna?

  1. AP6510DN
  2. AP8030DN
  3. AP8130DN
  4. AT815SN

Answer(s): B,D



A WLAN campus network adopts the independent AC (ACU2/AC6605/AC6005) deployment mode. This method does not support the following reliability methods. case?

  1. VRRP hot standby solution
  2. Dual-link cold standby solution
  3. Dual-link hot standby solution
  4. Stacking hot standby solution

Answer(s): D



The following statement about the connection of the device is wrong?

  1. The joints on the AP/power splitter/coupler/combiner/antenna are generally N-type male heads, and the two ends of the feeder are generally N-type female heads, and the two are connected to each other.
  2. Under normal circumstances, the indoor system or the longer distance (greater than 50 meters) uses 7/8 lines, and the tributary or short-distance transmission uses 1/2 feeders.
  3. 1/2 super soft feeder is very thin and filexible. It is generally used in the case where the gap is small or the turning angle is large.
  4. When the actual project calculates the feeder, the short feeder can directly calculate the number of standard feeders. After the long feeder needs to confirm the routing path, reserve 10%.
    ~20% feeder length

Answer(s): A






Post your Comments and Discuss Huawei H12-322 exam dumps with other Community members:

Join the H12-322 Discussion